ottoragam / Magnetic-Incremental-Rotary-EncoderLinks
This project aims to provide a compact, easy to use, relatively high resolution and arguably cheap encoder. It uses the AS5040 magnetic rotary encoder IC from Austria Microsystems.
☆12Updated 9 years ago
Alternatives and similar repositories for Magnetic-Incremental-Rotary-Encoder
Users that are interested in Magnetic-Incremental-Rotary-Encoder are comparing it to the libraries listed below
Sorting:
- MCU-based multipurpose Laser Diode driver☆19Updated 4 years ago
- Firmware for 3 Phase BLDC controller☆41Updated 5 years ago
- ☆16Updated 11 years ago
- CNC machine control modules with Toslink optical cables☆28Updated 8 years ago
- STM32 driven ARM Grbl firmware☆24Updated 5 years ago
- Hardware design for a 3 Phase BLDC controller☆56Updated 5 years ago
- PSoc5 Port of Grbl CNC Controller☆36Updated 8 years ago
- Closed Loop Motor Controller☆135Updated 4 years ago
- Otter's KiCAD-libs☆14Updated 6 months ago
- Closed loop servo control for stepper motors☆10Updated 9 years ago
- Mechaduino derivative which drives up to 10A, drawn using KiCad☆30Updated 6 years ago
- Open Source Brushless DC Servo☆13Updated 6 years ago
- USB Sink based around the STUSB4500☆27Updated 4 years ago
- Main Probe Scope PCB Repo☆57Updated 6 years ago
- CNC breakout for STM324F411 and ST32F446 development boards☆21Updated 2 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 11 months ago
- PCB files for the Adafruit USB Isolator☆16Updated 6 years ago
- Hardware files for OtterControl BLDC motor controller☆66Updated 5 years ago
- Open-Source Oscilloscope based on STM32F3-DISCOVERY board☆37Updated 4 years ago
- Low cost servo drive for small CNC machinery☆54Updated 8 years ago
- Build a basic Servo motor DC with Encoder and Blue pill, Step, Dir, Enable☆13Updated 6 years ago
- ☆17Updated 10 years ago
- grbl for stm32 with nucleo stepper drivers☆33Updated 4 years ago
- NXP MK20DX256 board for the Sparkfun MicroMod system. Should be able to run Teensy 3.2 firmware☆16Updated 4 years ago
- CNC laser cutter controller, compatible with LaserSaur but better.☆21Updated 13 years ago
- Various STM32 boards in a form factor similar to the Maple Mini or Blue Pill board☆50Updated 6 years ago
- STM32H7 Arduino form factor and software compatible board☆34Updated 4 years ago
- Open Source Lab Power Supply☆28Updated 3 years ago
- Stepper motor controller for solder paste dispensers☆30Updated 5 years ago
- TO247 half bridge module for EVs☆16Updated 6 years ago