EmanuelBender / HEX_PODLinks
Multi-sensor intelligent environmental Monitor
☆18Updated last year
Alternatives and similar repositories for HEX_POD
Users that are interested in HEX_POD are comparing it to the libraries listed below
Sorting:
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- Dual brushed motor ESC firmware compatible with brushless motor ESCs☆33Updated last year
- OpenFAN Micro is open-source open-hardware DIY fan controller for 5V and 12V fans with built in Web GUI and Web API☆25Updated 3 weeks ago
- 4 layer version of the Epi 32U4☆58Updated 2 years ago
- Introducing OpenRad, a simple radiation monitoring solution powered by the SBM-20 GM tube and TTGO ESP32 microcontroller. this project of…☆58Updated 3 weeks ago
- Li-Ion battery charger, based on BQ24060 IC☆45Updated 2 years ago
- Arduino TPMS - Tire Pressure Monitoring System☆117Updated 5 months ago
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆32Updated 9 months ago
- Multi Channel Configurable PID regulator on M5Stack Core☆50Updated last year
- Tiniest USB-C LiPo charger☆36Updated 3 years ago
- ☆45Updated 3 years ago
- Simple RPM-Meter☆57Updated 3 years ago
- DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.☆42Updated 3 years ago
- Simple design for 16x2 OLED Character Display using the US2066 chip☆13Updated 2 years ago
- ESP32-S3 Thermal Sensor using an 8-bit bus☆92Updated last year
- Quick and dirty PIC16F72 programmer using the Raspberry Pi Pico and MicroPython☆34Updated 2 years ago
- Power Supply Analyzer with USB Interface☆55Updated 3 years ago
- Simple Board that can be used as a Mouse Jiggler, a Rubber Ducky, or a Caps Blocker☆42Updated 2 years ago
- Simple library to exchange data between the 2 cores of a Raspberry Pi Pico under Arduino IDE framework☆27Updated 2 years ago
- Portable Digital FM Radio Receiver with RDS☆67Updated last year
- ESP32-C3 1.54inch E-ink Project☆29Updated 2 years ago
- A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico☆60Updated last year
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- Sailor Hat for Raspberry Pi hardware design files☆53Updated last year
- ☆14Updated 2 years ago
- Ultimate Continuity tester☆31Updated 5 years ago
- Connecting cheap digital calipers to Raspberry Pi and decode readings☆123Updated 10 months ago
- An open-source hardware project designed to offer a reliable and efficient power solution for breadboard prototyping. Featuring built-in …☆87Updated 6 months ago
- ☆27Updated 5 years ago
- DYI ATX PSU☆36Updated 3 years ago