t3chN0Mad / OpenXPBMSLinks
Open Source BMS(Battery Management System) for Valence XP Batteries
☆20Updated 4 years ago
Alternatives and similar repositories for OpenXPBMS
Users that are interested in OpenXPBMS are comparing it to the libraries listed below
Sorting:
- Battery cell monitor and balancer☆35Updated 2 months ago
- DC Motor Controler based on Benjamin Vedders VESC☆17Updated 3 years ago
- Arduino based Maximum Power Point Tracking (MPPT) solar charge controller☆79Updated 6 years ago
- Solar charge controller with integrated 12 V Li-Ion BMS☆15Updated 6 years ago
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆26Updated last year
- To measure temperature and barometric pressure with a BMP280 sensor and send it to NMEA2000 network.☆15Updated 2 years ago
- Battery management system for up to 5 Li-ion cells based on TI bq76920☆41Updated 6 years ago
- PID Controller using RTOS timers, based on Brett Beauregard's blog posts☆20Updated 5 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- Library for working with JBD BMS☆73Updated last year
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆54Updated 2 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 8 months ago
- ESP32 LoLin32 Lite Shield for RFM95 or RN2483 LoRa Modules☆26Updated 7 years ago
- Arduino-based battery internal resistance meter☆45Updated 8 years ago
- Arduino Current Transformer Library☆17Updated 5 years ago
- ☆36Updated 6 years ago
- Brain behind the DC to DC boost converter☆21Updated last year
- An open source Arduino ESP32 MPPT Charger firmware equipped with charging algorithms, WiFi, LCD menus & more!☆38Updated 4 months ago
- Smart Battery System for ESP☆74Updated 6 years ago
- ☆62Updated 6 years ago
- Opensource FrSky Mini RX☆23Updated 6 years ago
- Use a Nano to control the flow of energy from a Solar panel to a battery!☆18Updated 5 years ago
- CAN_Interface for ESP32 (Cannelloni Protocol)☆55Updated 4 years ago
- Hardware of Jasper's Electronic Load R3☆25Updated 6 years ago
- With these schematics and PCB's, it's possible to create a 230V AC 4KW inverter. The main processor is based on Arduino Nano, with help f…☆60Updated 3 years ago
- Our own dual BLDC Motorcontroller☆16Updated 2 years ago
- An open hardware platform for experimenting with DC-to-AC conversion, power and energy metering and grid tie inverters.☆70Updated last year
- DIY Multiprotocol TX Module☆15Updated 5 months ago
- This repository shows how to use the M5Stack as NMEA 2000 Display and WiFi Gateway.☆41Updated 3 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆72Updated last year