MMMZZZZ / Syntherrupter
Powerful MIDI interrupter with touchscreen for up to 6 tesla coils and 16 voices per coil.
☆27Updated 4 months ago
Alternatives and similar repositories for Syntherrupter:
Users that are interested in Syntherrupter are comparing it to the libraries listed below
- Reflow Oven Controller with EPS32 and Webapp☆40Updated 5 years ago
- DIY Electronic load for DCDC converter characterization☆51Updated 4 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆60Updated last year
- ☆29Updated 3 years ago
- Solder Reflow Plate PCB☆31Updated last year
- Open-Source firmware for the ZPB30A1 electronic load (WIP)☆50Updated 7 years ago
- New UD3 repository☆25Updated last week
- Precision auto-ranging current meter (ammeter)☆101Updated last month
- The ultimate battery tester with ESR measurement and discharge graph. Based on an Arduino Nano and a 1602 LCD.☆47Updated last month
- This is a dual channel linear lab power supply, each one capable of 30 V at 500 mA.☆13Updated 5 years ago
- Arduino library for INA3221 current and voltage sensor.☆16Updated 3 months ago
- ESP32 Oscilloscope clock using internal DACs, with WiFi ntp sync☆64Updated 3 years ago
- Power Supply Analyzer with USB Interface☆50Updated 2 years ago
- ☆43Updated last year
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 3 months ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆23Updated 2 years ago
- Nixie Clock driven by an ESP32☆50Updated 4 years ago
- A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)☆24Updated 2 weeks ago
- 170V, LT3757 based nixie power supply open source hardware☆50Updated 5 years ago
- Compact Volt / Amp meter using Arduino nano, a 128x32 OLED display and the INA219 high side current sensor.☆19Updated last year
- Stereo VU meter using OLED screens and AVR microcontroller☆128Updated 4 years ago
- Small prototype of ESP32 Reflow controller☆14Updated 3 years ago
- ☆19Updated last year
- Source code for my Best Improvement board v1.5 (RP2040) to control Best BST-863 hot air station☆17Updated last year
- OSC Calibrator and High-Voltage Fuse Resetter for 8-Pin ATtinys☆54Updated 2 years ago
- Using STM32F103C8 and NT35702 2.4" TFT.☆23Updated 8 months ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆124Updated 3 years ago
- A pack of PCBs for a dual resonant solid state tesla coil setup. Pretty much everything you need.☆46Updated 8 months ago
- Using an Arduino and 12 Volt to erase wrong ATtiny fuse settings by High-voltage Serial Programming☆21Updated 2 years ago
- 12-Button IR Remote Control☆45Updated 2 years ago