Integreight / 1Sheeld-BootloaderLinks
1Sheeld bootloader is a small piece of firmware that come pre-installed on your 1Sheeld board and is used mainly for flashing new firmware updates to the board using the app.
☆15Updated 9 years ago
Alternatives and similar repositories for 1Sheeld-Bootloader
Users that are interested in 1Sheeld-Bootloader are comparing it to the libraries listed below
Sorting:
- This repository contains the schematics, board and Fritzing part files for the 1Sheeld board.☆42Updated 8 years ago
- This is the source code of the firmware shipped with your 1Sheeld board. It is an implementation of a custom version of the Firmata proto…☆45Updated 7 years ago
- An Arduino library for 1Sheeld. It is the interface to your smartphone's accessories, sensors and virtual shields. It allows you to commu…☆58Updated 6 years ago
- A library that allows you to scan, connect and interact with 1Sheeld boards using your custom Android app.☆35Updated 8 years ago
- An Android app used along with our hardware shield to either control Arduino, read your smartphone's sensors in your Arduino sketch, post…☆72Updated 8 years ago
- ☆24Updated 10 years ago
- A simple way to add an LCD without using a lot of pins☆16Updated 2 years ago
- A simple continuity tester, based on an ATtiny85 and a piezo buzzer.☆18Updated 7 years ago
- ESP8266-based touchscreen clock and light controller with WiFi☆31Updated 9 years ago
- An Arduino library for the MicroView - a chip-sized Arduino with a built-in OLED, available from SparkFun Electronics☆21Updated 6 years ago
- Breakout board for a monochrome, 0.66", 64x48 OLED display.☆29Updated 6 years ago
- Reflow controller for toaster oven.☆21Updated 10 years ago
- 2.8" TFT Touch Shield For Arduino☆12Updated 5 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 5 years ago
- ☆24Updated 9 years ago
- H2OhNo! is a small ATtiny development board that detects the presence of water and sets off an alarm.☆27Updated 7 years ago
- SparkFun's adaptation of the FreeSoC project.☆16Updated 6 years ago
- Rocket Scream KiCad Library☆19Updated 9 years ago
- Home logging station☆12Updated 4 years ago
- firmware for on a EspLight Board.☆9Updated 9 years ago
- upload dos arquivos do Fritzen Proto, um compatível com Arduino UNO para protoboard☆11Updated 8 years ago
- Firmware library for the MAX17043 LiPo fuel gauge IC - used on SparkFun's Photon Battery Shield.☆15Updated 5 years ago
- nRF24L01 multi-protocol RC transmitter☆11Updated 9 years ago
- Switcher – A WiFi Open Source Power Switch☆37Updated 8 years ago
- Isolated USB Serial Interface☆17Updated 9 years ago
- An Arduino WiFi Shield based around the Espressif ESP8266 WiFi SoC.☆14Updated 9 years ago
- ☆16Updated 12 years ago
- ATTiny Core for Arduino 1.0+☆88Updated 8 years ago
- Arduino library and example code for RFToy -- an Arduino-compatible gadget for RF modules. Check http://rftoy.rayshobby.net.☆32Updated 10 years ago
- ESPToy is an Arduino-compatible gadget for the ESP8266 WiFi module☆43Updated 5 years ago