HydroPWNics / SunLeafLinks
SunLeaf is a WiFi based remote sensor module, interfaces with I2C and UART sensors, pushes directly to the cloud.
☆22Updated 8 years ago
Alternatives and similar repositories for SunLeaf
Users that are interested in SunLeaf are comparing it to the libraries listed below
Sorting:
- FemtoBeacon - Atmel SAM R21 (ARM Cortex M0+, SAM D21 with built in AT86RF233)☆66Updated 5 years ago
- ESP32 IoT board with 4MB external RAM, 4MB external Flash, LiPo charger, external crypto engine USB-OTG☆50Updated last year
- PiRA - Power in Responsive Applications HAT for Raspberry Pi Zero with RTC for power saving mode.☆11Updated 7 years ago
- Resources for MightyWatt R3 electronic load☆31Updated last week
- Hardware of Jasper's Electronic Load R2☆22Updated 7 years ago
- My Open Source Hardware (OSHW) projects☆17Updated 4 years ago
- STM32WL SOC LoRa / LoRaWAN development board with JTAG debugger and sensors for light, temperature, humidity, pressure, 3-axis digital ma…☆15Updated last week
- Fully isolated, input debounce Hat for Raspberry Pi, for up to 6 switches, relays and powered devices☆23Updated 5 years ago
- ☆15Updated 7 years ago
- Various PCB designs in KiCad☆70Updated 11 years ago
- Various versions of my MPPT Solar Charger☆59Updated 7 years ago
- USB Sink based around the STUSB4500☆27Updated 4 years ago
- ESP32 Audio Development Framework development board☆34Updated 4 years ago
- CDM324 Amplification Backpack, With Case and Simulations☆61Updated 8 years ago
- cupl Tag Firmware and Hardware☆15Updated 2 years ago
- ESTechnical Reflow Oven Controller source code and instructions☆47Updated 10 years ago
- MicroPython - a lean and efficient Python implementation for microcontrollers and constrained systems☆29Updated 7 years ago
- USB-PD firmware for the stm32f072 - forked from https://git.clayhobbs.com/pd-buddy/pd-buddy-firmware☆31Updated 5 years ago
- An esp32-s2 based development board in a tiny form factor 🚀☆22Updated 4 years ago
- Hardware design files for Simmel☆15Updated 5 years ago
- Breakout board for LoRa all-in-one module CMWX1ZZABZ☆13Updated 5 years ago
- Hacking a cheap IP camera from Banggood☆17Updated 6 years ago
- One inch ESP32 PCB designed for low power IoT applications.☆20Updated 6 years ago
- Oscilloscope to footswitch interface for run control using USBTMC☆19Updated 5 years ago
- A small Black Magic Probe based on the pinout of the STLink V2 support firmware☆35Updated 6 years ago
- ☆19Updated 7 years ago
- FPGA-based shield for Arduino☆72Updated 10 years ago
- Current-fed dual inductor converter with wide input and output voltage range☆19Updated 6 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- HackAday Cortex Kit☆18Updated 9 years ago