Hunv / can2mqttLinks
A Linux or Windows service to forward CAN frames to MQTT messages. Optimized for Stiebel Eltron (at the Moment) but works for all.
☆23Updated 7 months ago
Alternatives and similar repositories for can2mqtt
Users that are interested in can2mqtt are comparing it to the libraries listed below
Sorting:
- ESPhome-configuration to read and write values on a Stiebel Eltron heat pump☆26Updated 8 months ago
- OpenSource ISG for Stiebel Eltron & Tecalor heat pumps☆34Updated last week
- Interact with Zehnder Comfoair Q using ESPHome and Home Assistant☆51Updated last week
- Panasonic Aquarea air-water H, J, K and L series protocol decrypt☆298Updated last month
- An ESPhome / Home Assistant configuration to monitor & configure Stiebel Eltron Heating Pumps via a CAN Interface☆42Updated 6 months ago
- An implementation of the Tigo TAP protocol☆54Updated 6 months ago
- Interact with Zehnder Comfoair with esp32☆137Updated last month
- ☆51Updated 5 months ago
- ☆73Updated last week
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆103Updated last month
- Software for an esp8266 nodemcu to read data from APS inverters.☆141Updated last year
- ESPHome component to monitor a Seplos Battery Management System (Seplos-BMS) via UART, RS485 or BLE☆100Updated 3 weeks ago
- Controller for HmIP-VdMot actuators☆61Updated 2 months ago
- Monitor and control Daikin/Rotex Altherma heat pumps from Home Assistant directly via the 2-wire P1/P2 thermostat interface. Also enables…☆386Updated 3 weeks ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆92Updated last month
- Firmware for ESP8266 allowing eBUS communication for ebusd (https://github.com/john30/ebusd)☆157Updated last year
- ESPHome configuration to drive Zehnder ComfoAir devices.☆66Updated last week
- ESPHome component to read out DLMS smart meters via M-Bus☆114Updated last year
- Growatt Solar Inverter Modbus Data to MQTT Gateway☆170Updated 2 years ago
- Esphome component for Deye 3 phase inverters for Home Assistant☆179Updated 8 months ago
- esphome component to connect to Hörmann Garage Door☆32Updated last year
- A smart home interface for Sofar solar and battery inverters.☆83Updated last year
- Emulates Hörmann UAP1-HCP board using an ESP32 and a RS485 converter, and exposes garage door controls over web page and MQTT.☆109Updated this week
- Firmware replacement for Growatt ShineWiFi-S☆391Updated 3 months ago
- ESP8266 and ESP32 compatible firmware to read, interpret and publish data to MQTT from smart electrical meters, both DLMS and DSMR is sup…☆413Updated this week
- ☆77Updated 5 months ago
- Open source alternative for Panasonic air condition wifi adapters that works locally without the Comfort Cloud☆310Updated last month
- Use official Victron BLE endpoint for fetching data from Victron devices via Bluetooth LE via ESPHome.☆313Updated 2 months ago
- esphome firmware for esp32_8ch_motor_shield☆51Updated 2 months ago
- ESP32 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆765Updated last week