FEDEVEL / board-imx6rex-module-in-cadence
Open Source iMX6 Rex module design files in Cadence. More at:
☆16Updated 6 years ago
Alternatives and similar repositories for board-imx6rex-module-in-cadence:
Users that are interested in board-imx6rex-module-in-cadence are comparing it to the libraries listed below
- 4-Layer XC7Z010 DDR3 Layout☆16Updated 3 years ago
- ☆26Updated 4 years ago
- KiCad PCB project of Logic Analyzer☆39Updated 4 years ago
- STM32F407 + Spartan6 combo with high speed USB TMC interface☆28Updated 5 years ago
- ☆48Updated 4 years ago
- SpaceVNX (VITA 74.4) carrier based on Zynq-7000.☆13Updated 2 years ago
- Yet Another XC7Z010 Board☆17Updated 3 years ago
- Example Hazard3 + OpenDAP RISC-V SWD SoC integration☆9Updated 2 years ago
- Xilinx Virtual Cable Daemon☆19Updated 5 years ago
- Open Hardware Zynq System on Module☆29Updated 9 years ago
- Eagle design files of a two layer PCB for the ALTERA EP3C5E144 FPGA, including a FTDI USB2.0 controller, 2x 80 MSPS ADC, GPIO, JTAG, conf…☆12Updated 10 years ago
- Adapter board exposing SATA M.2 SSD on FMC board-to-board connector☆11Updated last year
- ☆18Updated 9 years ago
- Vivado project for Xilinx Artix FPGA, used in logic analyzer☆13Updated 3 years ago
- RMII interface ethernet MAC Core for 10/100 MBit ethernet implementation with support CDC and AXI-Stream BUS without management and witho…☆12Updated 3 years ago
- MIPI CSI-2 Camera Sensor Receiver V2 Verilog HDL implementation For any generic FPGA. Tested with IMX219 IMX477 on Lattice Crosslink NX w…☆55Updated 2 months ago
- ☆37Updated 4 years ago
- Control a MIPI Camera over I2C☆21Updated 4 years ago
- Open source zynq platform☆18Updated 6 years ago
- This repo contains source, Documentation/reference PCB boards for USB3 camera interface with Lattice Crosslink NX FPGA☆14Updated 2 years ago
- STM32-H407 and STM32-E407☆30Updated 7 years ago
- Streaming video over USB 3.0 using MAX10 FPGA and CYUSB3014 synchronous slave mode.☆20Updated 3 years ago
- FPGA core boards / evaluation boards based on CDCTL hardware☆92Updated 3 years ago
- The program for USB-Blaster Chinese version on STM32 works with☆31Updated 7 years ago
- Open Hardware carrier board supporting modules with Zynq 7000 All Programmable SoC devices.☆58Updated last year
- 蚂蚁S9矿板移植pynq2.5☆26Updated 4 years ago
- ☆21Updated 3 years ago
- 12.5 MHz - 6400 MHz (LMX2572) or even up to 20 GHz (LMX2595) generator board with int./ext. reference.☆15Updated 3 years ago
- FPGA Software for the Probe-Scope☆18Updated 5 years ago
- RISC-V Architecture☆20Updated 2 years ago