Alternatives and similar repositories for geiger_pen

Users that are interested in geiger_pen are comparing it to the libraries listed below

• wasspaul / sig_gen
  A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico
  ☆60Updated last year
• wagiminator / CH32V003-FM-Receiver
  Portable Digital FM Radio Receiver with RDS
  ☆67Updated last year
• oxullo / uctester
  Ultimate Continuity tester
  ☆31Updated 5 years ago
• cnlohr / cnixxi
  My experiment with nixie tubes.
  ☆144Updated 5 months ago
• rin67630 / Drok-Juntek-on-steroids
  Extend the possibilities of cheap digital power supplies with a WiFi module
  ☆59Updated last year
• ArduinoHannover / ZPB30A1_Firmware
  Open-Source firmware for the ZPB30A1 electronic load (WIP)
  ☆51Updated 7 years ago
• knifter / DualPID
  Multi Channel Configurable PID regulator on M5Stack Core
  ☆50Updated last year
• dobrishinov / PowerLinkESP
  Enhancing Nice-Power Bench Power Supplies with ESP8266 Connectivity
  ☆68Updated last year
• omarkhorshid / OpenRad
  Introducing OpenRad, a simple radiation monitoring solution powered by the SBM-20 GM tube and TTGO ESP32 microcontroller. this project of…
  ☆58Updated 3 weeks ago
• 0xjmux / ESP-PROG-Adapter
  Adapter PCB and Kicad Library to make adding component-less program and debug footprints to your PCBs as easy as possible
  ☆50Updated 5 months ago
• wagiminator / ATtiny814-Power-Analyzer
  Power Supply Analyzer with USB Interface
  ☆55Updated 3 years ago
• atc1441 / ATC_stc_solder_iron
  Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based
  ☆50Updated 2 years ago
• nerdralph / ArduinoShrink
  replaces Arduino AVR Core functions with smaller and faster versions
  ☆133Updated 9 months ago
• alunmorris / Multi-channel-autorange-OLED-voltmeter
  Minimalist 4-channel 0 to 27V meter using AVR microcontroller and 72x40 OLED display
  ☆20Updated last year
• g3gg0 / ESP232
  ☆44Updated 2 years ago
• hatlabs / SH-RPi-hardware
  Sailor Hat for Raspberry Pi hardware design files
  ☆53Updated last year
• yellobyte / ElectronicLoad-Control-XY-FZ35
  Control Program for Electronic Loads XY-FZ25 and XY-FZ35
  ☆31Updated 9 months ago
• MagnusThome / Capacitive-Rainmeter
  Measure rain intensity in Homeassistant with a capacitive sensor
  ☆19Updated 2 years ago
• markus-seidl / component-tester
  GM328A / KKMOON Transitor / Component Tester Firmware
  ☆44Updated 6 years ago
• wagiminator / CH32V003-USB-Joystick
  Simple Joystick with USB Interface
  ☆31Updated last year
• SyedTahmidMahbub / q-dpico_picprog72
  Quick and dirty PIC16F72 programmer using the Raspberry Pi Pico and MicroPython
  ☆34Updated 2 years ago
• ripred / CPUVolt
  Library for Arduino and ATmega series processors to read the processor's Vcc voltage and percentage of capacity (for battery based projec…
  ☆79Updated 11 months ago
• takigama / KmartReflowMiniOven
  Reflow Oven from the KMart mini oven
  ☆12Updated 10 months ago
• foxieproducts / cardclock
  Foxie CardClock source
  ☆34Updated last year
• DoganM95 / CH340C-Serial-Programmer
  CH340C based ESP32 programmer module pcb with auto- programming & reset, sponsored by PCBWay.
  ☆40Updated 11 months ago
• SeryDesigns / Battery-Charger
  Li-Ion battery charger, based on BQ24060 IC
  ☆45Updated 2 years ago
• Aylo6061 / PDHV
  ☆34Updated 2 years ago
• wagiminator / ATtiny13-TinyProbe
  Simple Logic Probe
  ☆42Updated 3 years ago
• Matthias-Wandel / caliper-interface
  Connecting cheap digital calipers to Raspberry Pi and decode readings
  ☆123Updated 10 months ago
• joao-pinheiro / atx_psu
  DYI ATX PSU
  ☆36Updated 3 years ago