Aus3D / MagneticEncoder
☆17Updated 7 years ago
Alternatives and similar repositories for MagneticEncoder:
Users that are interested in MagneticEncoder are comparing it to the libraries listed below
- Automatic SMT Tape Feeder by Pham Thang☆19Updated 7 years ago
- Firmware for the 0816 automatic 3d printed smt feeder for OpenPnP.☆34Updated 2 years ago
- tape puller/remover for 0816 automatic feeder☆21Updated 5 years ago
- A 3D printer board using a powerfull STM32 MCU, TMC5160/TMC2160 driver and a Raspberry Pi or compatible SBC☆39Updated 4 years ago
- Better webUI for Smoothieware☆21Updated 8 years ago
- MKS SERVO57B is 3d printer closed loop stepper motor NEMA23 MKS SERVO57 developed by Makerbase that prevents losing steps. CPU is STM32F1…☆21Updated 3 years ago
- Hardware information for the Duet 3 Mainboard 6HC☆44Updated last year
- ☆74Updated 2 years ago
- Plugins overview☆26Updated last month
- Digital Readout sketch files for the Arduino IDE☆10Updated 4 years ago
- The closed-loop drive is to feedback the rotation angle of the stepping motor to the control panel, compare the distance that needs to be…☆25Updated 5 years ago
- ☆28Updated 4 years ago
- The G-EDM is a 4in1 electrical discharge machine that supports sinker EDM, EDM engraving, EDM drilling and Wire EDM operations. In the fu…☆49Updated 7 months ago
- Probe Wizard for Mach3☆30Updated 5 years ago
- Open source pick and place machine☆24Updated 7 months ago
- A powerful 32-bit 3D printer control board.☆71Updated 4 years ago
- Cycloidal Gear Generator for Fusion 360☆24Updated 8 years ago
- grblHAL drivers for simulation (Linux and Windows)☆30Updated this week
- 3D printer / slicing GUI built on top of the Uranium framework☆35Updated 4 years ago
- A CNC controller to use and test Grbl_ESP32☆76Updated 4 years ago
- ☆54Updated last year
- ☆18Updated 6 months ago
- List of controllers supported by grblHAL☆41Updated 2 weeks ago
- Buildbotics CNC Controller Firmware☆69Updated last month
- Low-cost and simple GRBLHAL to MACH3 BOB bridge for Raspberry Pi Pico☆27Updated 3 weeks ago
- Low cost servo drive for small CNC machinery☆54Updated 8 years ago
- ☆34Updated last year
- ☆21Updated 3 years ago
- Expatria Technologies GRBLHAL Breakout board for PrintNC☆30Updated last year
- Firmware for Replicape☆36Updated 2 years ago