Apehaenger / Another-HotPlate-Firmware
A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)
☆24Updated last year
Alternatives and similar repositories for Another-HotPlate-Firmware:
Users that are interested in Another-HotPlate-Firmware are comparing it to the libraries listed below
- Thermocouple based, ESP32 driven PID-controller software for SMD reflow soldering☆22Updated 3 years ago
- Reflow Oven Controller with EPS32 and Webapp☆40Updated 5 years ago
- ESP8266 reflow controller☆23Updated 2 years ago
- The source code for my reflow oven, WARNING use at your own risk. This project deals with MAINS VOLTAGES which can kill.☆23Updated 4 years ago
- Solder Reflow Plate PCB☆31Updated last year
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆23Updated 2 years ago
- Simple USB-C Power Delivery Tester☆37Updated 2 years ago
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 2 months ago
- ☆29Updated 3 years ago
- Source code for my Best Improvement board v1.5 (RP2040) to control Best BST-863 hot air station☆17Updated last year
- ESP3D Firmware for ESP32 based TFT☆44Updated last month
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- ATmega32-based amplifier control module with 32-band spectrum analyzer and FM radio support☆39Updated last year
- Programmable MacroPad with Rotary Encoder and NeoPixels☆10Updated 7 months ago
- ☆16Updated 2 years ago
- Electronic Dummy Load☆47Updated 2 years ago
- The ultimate battery tester with ESR measurement and discharge graph. Based on an Arduino Nano and a 1602 LCD.☆45Updated 3 weeks ago
- Simple Logic Probe☆41Updated 2 years ago
- Multi-sensor intelligent environmental Monitor☆17Updated last year
- Bluetooth LE temperature controller for the 946C electronic hot plate☆108Updated 11 months ago
- Hot air rework controller for generic 858D / 8586 / 8858 / 852 / 878 / 858 hot air guns from China.☆31Updated 5 years ago
- ESP32-C3 1.54inch E-ink Project☆27Updated last year
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated 11 months ago
- ☆16Updated 4 years ago
- This repo contains all the files of my Arduino Nano based Reflow Oven PID Controller for reflow smd soldering.☆16Updated 11 months ago
- Simple Candle Simulation☆13Updated 2 years ago
- ☆35Updated 2 months ago
- DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.☆33Updated 3 years ago
- Rotary Encoder with I²C Interface☆44Updated 2 years ago
- Single-Cell Li-Ion Battery Charger with Monitoring☆63Updated 2 years ago