AlexAsplund / Vanchor
An open source trolling motor. Features Hold heading, Hold Position, AutoPilot (NMEA APB & GPX). It still needs a lot of work but it's functional.
☆84Updated 3 years ago
Alternatives and similar repositories for Vanchor:
Users that are interested in Vanchor are comparing it to the libraries listed below
- M5Stack Tough (ESP-32) Sailing Instruments Display and Autopilot Control☆107Updated 2 months ago
- A simple Arduino sketch that allows you to send data to Torque Pro for Android☆22Updated 3 years ago
- ESP32 BLE Tire Pressure Management System☆97Updated 4 years ago
- ☆39Updated 5 years ago
- A Teensy 3.6-based logger and gauge for my 2014 Subaru STI.☆16Updated 4 years ago
- Sailor Hat for ESP32 hardware☆46Updated 6 months ago
- Material für den NMEA2000-Workshop.☆39Updated last year
- ☆30Updated 2 years ago
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆57Updated 3 years ago
- Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display☆110Updated 9 months ago
- ☆41Updated 5 years ago
- ESP32 based CAN development board☆172Updated 3 years ago
- Universal Signal K sensor framework for the ESP32 platform☆173Updated last month
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆27Updated 6 months ago
- Sailor Hat for Raspberry Pi hardware design files☆50Updated 4 months ago
- Arduino project for Subaru SSM to Can-bus conversion☆13Updated 4 years ago
- nmea2000 gateway with ESP32☆75Updated this week
- An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32☆31Updated last year
- Experimental - OBD2 to feed custom device via bluetooth☆87Updated 8 months ago
- This repository shows how to build a NMEA2000 WiFi Gateway with voltage and temperature alarms.☆79Updated 3 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆32Updated 5 years ago
- Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3☆27Updated 6 months ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆47Updated last month
- Tunerpro checksum plugins for GM PCM files☆41Updated 7 months ago
- Raspberry Pi / Teensy based Digital Gauge Cluster☆69Updated 2 years ago
- Hardware circuit diagram for interfacing to the Webasto WBUS interface from a PC/Arduino☆23Updated 5 years ago
- This repository shows how to use the M5Stack as NMEA 2000 Display and WiFi Gateway.☆38Updated 3 years ago
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆53Updated 4 months ago
- ☆72Updated last week
- 8Ch EGT sensor board to be used with aftermarket ECUs☆31Updated last year