zxombie / contiki-arduino
Contiki ported to various Arduino boards
☆24Updated 15 years ago
Alternatives and similar repositories for contiki-arduino
Users that are interested in contiki-arduino are comparing it to the libraries listed below
Sorting:
- An Arduino sketch that can upload sketches to other boards.☆40Updated 9 years ago
- ☆28Updated 13 years ago
- Raspberry PI Lora Gateway/Node for RFM92/95/96/98/69HCW Modules☆61Updated 8 years ago
- Port of uIP library to Nanode☆38Updated 13 years ago
- Board with AVR and Ethernet supporting MQTT☆15Updated 10 years ago
- Broadcom WICED patches for MXCHIP EMW wireless ARM platform. Not affiliated with MXCHIP or Broadcom☆55Updated 5 years ago
- RAKwireless,BLE5.0,LoRaWAN,nRF52832,GPS,MEMS,LCD,RAK815☆2Updated 5 years ago
- Arduino clone based on the ATmega644P/ATmega1284P☆34Updated 6 years ago
- Port of pre-1.0 Arduino bootloader and core for the Zigduino, a shield-compatible Arduino clone based on the Atmega128RFA1.☆25Updated 12 years ago
- Control Panel and connectors for Arduino Uno WiFi☆43Updated 8 years ago
- Read more about this at☆20Updated 11 years ago
- Linux RTL8710AF below the GCC version, you can Ubuntu, CentOS, Fedora and so on the development of the SDK environment, support the compi…☆37Updated 5 years ago
- Connecting mesh network to the MQTT broker and tunneling MQTT protocol over Websocket.☆41Updated 7 years ago
- ☆31Updated 3 years ago
- An evolution of the Qt-based Funcube Dongle HID controller.☆44Updated 9 years ago
- Driver for Microchip UNI/O devices on Nanode (eg. the MAC address chip)☆25Updated 13 years ago
- RFM92W/93W - Arduino Powered Low Power Long Range LoRa Transceiver☆26Updated 10 years ago
- Ethernet packet handling using ESP8266☆10Updated 9 years ago
- Arduino port of the Atmel Lightweight Mesh framework☆14Updated 9 years ago
- Unofficial Development Kit for Espressif ESP32☆35Updated 5 years ago
- This role installs all the esp8266 development environment.☆12Updated 9 years ago
- GPRS Shield based on SIM900☆47Updated 7 months ago
- This library is used to connect CC2500 RF Module (Texas Instruments) with Arduino. This library is tested on Arduino UNO.☆44Updated 10 years ago
- CW Beacon on Arduino+si4463☆48Updated 4 years ago
- Semtech's LoRa RF drivers for mbed OS☆33Updated 4 years ago
- SDK for the Nordic nRF24LE1 for use with SDCC☆36Updated 11 months ago
- Git repository for RadioHead wireless networking library.☆49Updated 2 months ago
- MCU driver/HAL for the Picocell Gateway concentrator board.☆53Updated 5 years ago
- PCB for NoceMCU based Energy Monitor☆19Updated 9 years ago
- Library for Arduino IDE to send AT or ASCII commands via UART☆45Updated 4 years ago