yeokm1 / reverse-engineering-ndp2016-wristbandLinks
Schematics of the reverse engineered Pixmob wristband used in NDP2016. Sample IR brute-force code is available but has not been fully tested in practice.
☆28Updated 9 years ago
Alternatives and similar repositories for reverse-engineering-ndp2016-wristband
Users that are interested in reverse-engineering-ndp2016-wristband are comparing it to the libraries listed below
Sorting:
- Run a dim LED + microcontroller on 10 uA? Sure! A ripoff of Ted Yapo's Tritilight Project☆38Updated 8 years ago
- Allows you to use an Arduino to capture LoRa radio network traffic and transfer to a PC for viewing or saving to disk.☆64Updated 8 years ago
- Tear-down effort of the Pixmob wristband used in NDP2019.☆48Updated 6 years ago
- DroidScript for easier use of the BusPirate on your Android device.☆45Updated 8 years ago
- Arduino (328P) based OBD port module☆33Updated 9 years ago
- HAB Firmware for the S7xG board in the LilyGo Watch, to provide basic GPS and LoRa for UKHAS telemetry☆20Updated 5 years ago
- Library for the Dangerous Prototypes Bus Pirate☆40Updated 3 years ago
- An Open Source USB Stick compatible with LoRa and LoRaWAN with Cortex M0+. To connect, review and analyze packages of LoRa®☆45Updated 5 months ago
- BusPirate Console☆39Updated 8 years ago
- USB bootloader for the CC1111 RF SoC (rfcat version)☆33Updated 2 years ago
- MASLOW: an Open WiFi Detector with ESP8266☆22Updated 9 years ago
- esp8266 Adruino Wifi Sniffer☆31Updated 10 years ago
- Soundcard RFID decoder for 125KHZ HID cards.☆27Updated 9 years ago
- Driving one of those cheap RF1101SE boards with a Arduino or Teensy☆62Updated 8 years ago
- Troubleshooting tool for embedded devices available from SparkFun Electronics☆75Updated 6 years ago
- An Open Source software for connect, review and analyze packages of LoRa®, we recommend using with catWAN USB Stick☆22Updated 2 years ago
- M5Stack Serial Monitor for FTDI with USB Host Module☆21Updated 4 years ago
- Example of using an Arduino and a nRF24L01+ to fake BLE advertisement☆69Updated 11 years ago
- Originally intended to be a controller for a RetroPie. A soft power controller that allows for Raspberry Pi proper shutdown. Intention is…☆22Updated 8 years ago
- OOK tx example for TI CC1101 with arduino☆36Updated 3 years ago
- Scan I2C buses and identify devices which respond.☆23Updated 6 years ago
- Utilities for sniffing bluetooth low-energy (BLE) packets using a CC2540 USB sniffer dongle☆29Updated 5 years ago
- Hacking nRF24L01+ as a low-cost BLE beacon☆63Updated 7 years ago
- Open source I2C based datalogger. The bigger, better cousin to the original serial OpenLog.☆24Updated 2 years ago
- Random collection of breakout boards☆14Updated 3 weeks ago
- Software-only ESP8266 USB Device☆10Updated 6 years ago
- M5Stack Thermal Camera with AMG8833 thermal sensor. The connection between M5Stack & the sensor is I2C☆63Updated 7 years ago
- A remote control clone of an RC-switch using Arduino Nano and a TI CC1101 module☆34Updated 5 years ago
- ESP32 firmware app that monitors deauthentication packets to and from a target AP☆22Updated 8 years ago
- Footprints, models and miscellaneous hardware files☆13Updated 6 years ago