wagiminator / ATtiny13-NeoControllerLinks
Control almost any number of NeoPixels with an IR Remote
☆22Updated 2 years ago
Alternatives and similar repositories for ATtiny13-NeoController
Users that are interested in ATtiny13-NeoController are comparing it to the libraries listed below
Sorting:
- IR Remote Receiver and Decoder☆49Updated 2 years ago
- Single-Cell Li-Ion Battery Charger with Monitoring☆65Updated 2 years ago
- Hot air rework controller for generic 858D / 8586 / 8858 / 852 / 878 / 858 hot air guns from China.☆31Updated 5 years ago
- Simple USB Power Tester☆55Updated 2 years ago
- Simple USB-C Power Delivery Tester☆38Updated 2 years ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆28Updated 2 years ago
- Simple RPM-Meter☆57Updated 2 years ago
- 12-Button IR Remote Control☆45Updated 2 years ago
- IR Remote Control☆82Updated 3 years ago
- USB controlled OLED Display☆74Updated 3 years ago
- Simple Logic Probe☆42Updated 2 years ago
- A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)☆25Updated 6 months ago
- Component Tester in a Keychain☆75Updated 3 years ago
- Power Supply Analyzer with USB Interface☆53Updated 2 years ago
- Electronic Dummy Load☆50Updated 2 years ago
- Thermocouple based, ESP32 driven PID-controller software for SMD reflow soldering☆23Updated 3 years ago
- Ampcontrol port on STM32F103CBT6☆38Updated 3 months ago
- an usb power delivery powerbank pcb based on IP5328P chip, feel free to use it☆49Updated 4 years ago
- FT81x on ST7701S Arduino Driver☆59Updated last year
- arduino for w60x platform☆31Updated 6 years ago
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- OSC Calibrator and High-Voltage Fuse Resetter for 8-Pin ATtinys☆58Updated 2 years ago
- FM Radio with RDS☆74Updated 6 months ago
- Simple Continuity Tester☆25Updated 2 years ago
- Using Heltec ESP32 MCU to control an ADAU1701 audio DSP via I2C.☆10Updated 2 years ago
- Info, instructions and examples for the ESP32 i2s Matrix Shield available on Tindie☆38Updated 4 years ago
- ESP32 programmer built on CH340G☆28Updated last year
- This project is all about getting your compiled sketch onto your target board without the need to have a connection to a computer running…☆11Updated 4 years ago
- The source code for my reflow oven, WARNING use at your own risk. This project deals with MAINS VOLTAGES which can kill.☆23Updated 4 years ago
- ESP32-C3 1.54inch E-ink Project☆29Updated 2 years ago