valtsu23 / DIY-Emu-Black-DashLinks
Raspberry pi based digital dash working with Ecumaster Emu Black
☆25Updated 3 months ago
Alternatives and similar repositories for DIY-Emu-Black-Dash
Users that are interested in DIY-Emu-Black-Dash are comparing it to the libraries listed below
Sorting:
- Raspberry Pi 4 Model B, with 5 inch display working as car gauge cluster. Data is read from Ecumaster Emu Black can bus stream and from D…☆12Updated 4 months ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆37Updated 2 years ago
- CANbus shift light, works with Neopixels and MCP2515 to make a shiftlight that works over CAN.☆18Updated 4 months ago
- A digital dashboard using Python, Raspberry Pi Zero W, and vehicle's On Board Diagnostics (OBD-II) Port.☆29Updated 4 years ago
- Zero Motorcycles alternative dashboard using a tft and the canbus and an Adafruit Esp32☆14Updated 3 years ago
- This is a Oled based speeduino display that polls data over Serial3☆14Updated 4 years ago
- EMS boards powered by Speeduino☆88Updated 7 months ago
- This is a LCD based speeduino display that polls data over Serial3☆19Updated 4 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- Digital Dash 'backend' for Holley/Racepak CAN protocol☆52Updated last year
- Raspberry Pi / Teensy based Digital Gauge Cluster☆70Updated 2 years ago
- ECU designed for Speeduino firmware☆32Updated 5 years ago
- OBD2 Car-Display written in python for a Raspberry Pi with 480x320 display☆24Updated 5 years ago
- EMS boards powered by Speeduino☆12Updated 5 months ago
- ☆13Updated 3 years ago
- ☆11Updated 3 months ago
- A dash project for tunerstudio based on RASPBIAN☆28Updated 4 months ago
- ☆124Updated 4 months ago
- Arduino/Teensy CAN Gauges with OLED displays☆16Updated 7 years ago
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆17Updated last year
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆32Updated 5 years ago
- The best way to share your FOME, Speeduino and rusEFI tunes and logs☆64Updated last year
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆80Updated last week
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆48Updated 2 months ago
- Official Speeduino hardware designs☆195Updated 8 months ago
- ☆12Updated 5 years ago
- Gauge.S is all-car datalogger and development board.☆49Updated 2 weeks ago
- Speeduino universal firmware loader☆49Updated 2 months ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆48Updated 4 months ago
- ☆11Updated 5 years ago