tvixen / diy-BMS-with-Arduino-NanoLinks
If you have a private powerwall of 18650 cells, this is the battery management system you need. The small PCB is equipped with the cheap Arduino Nano.
☆43Updated 6 years ago
Alternatives and similar repositories for diy-BMS-with-Arduino-Nano
Users that are interested in diy-BMS-with-Arduino-Nano are comparing it to the libraries listed below
Sorting:
- Battery cell monitor and balancer☆36Updated 7 months ago
- Arduino based Maximum Power Point Tracking (MPPT) solar charge controller☆80Updated 7 years ago
- ☆39Updated 6 years ago
- Work in progress. Single ESP32 monitoring and balancing multiple cell Li-Ion battery.☆25Updated 4 years ago
- Arduino controlled Spot Welder for battery welding☆78Updated 7 years ago
- ☆18Updated 5 years ago
- Reflow controller with ESP32 and TFT LCD on board.☆69Updated 6 months ago
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆27Updated last year
- Arduino firmware for a Lithium-Ion battery charger☆42Updated last year
- Reflow Oven Controller with EPS32 and Webapp☆43Updated 6 years ago
- A CNC controller to use and test Grbl_ESP32☆79Updated 5 years ago
- Variable Frequency Drive for ATmega328 based Arduinos☆86Updated 7 years ago
- DIY Electronic load for DCDC converter characterization☆51Updated 5 years ago
- Uninterruptible Power Supply☆165Updated 3 years ago
- 12V Automatic UPS system☆45Updated 4 years ago
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆54Updated 2 years ago
- ☆63Updated 6 years ago
- The soldering controller for hakko 907 with lcd screen☆29Updated 6 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- WebSocket to Serial bridge for LaserGRBL☆77Updated 7 years ago
- Arduino-based battery internal resistance meter☆46Updated 9 years ago
- An ATTiny version of Julian Iletts PWM5 Solar Charge Controller☆50Updated 4 years ago
- (de)soldering station☆28Updated 8 years ago
- Telnet to Serial bridge for LaserGRBL☆53Updated 8 years ago
- This motor driver is designed to be interfaced from a host microcontroller by I2C and be able to control the motor with a PID autonomousl…☆33Updated 3 years ago
- Optiboot subtree for MightyCore, MegaCore, MiniCore and MajorCore☆59Updated 3 years ago
- cheap lipo charger☆31Updated last year
- Semi-automatic passive printable/castable feeder for LitePlacer☆59Updated 5 years ago
- VC288 Volt-amp meter alternative firware. Targets the cheap DSN-VC288 volt-amp meter and the STM8S003F MCU.☆25Updated 4 years ago
- AVR-based universal battery charger☆48Updated 6 years ago