tommybobbins / PiThermostatLinks
Raspberry Pi and Shelly relay to make an Redis based Central heating / Hot water system. Previously this was setup to connect to a British Gas/Drayton 433 wireless receiver.
☆12Updated 5 months ago
Alternatives and similar repositories for PiThermostat
Users that are interested in PiThermostat are comparing it to the libraries listed below
Sorting:
- Publish dash button presses to a MQTT broker 🔘📡☆16Updated 7 years ago
- ESP8266 / H801 RGB controller using MQTT and WiFi onboarding☆30Updated 9 months ago
- Python script for sending/receiving commands to/from GPIO pins via MQTT messages☆46Updated 6 years ago
- Chinse Wifi rgbww controller module hack☆52Updated 9 years ago
- Home Automation Room Controller☆46Updated 9 years ago
- 433Mhz <-> MQTT gateway for smart home 🏡 automation☆40Updated 8 years ago
- ☆23Updated 8 years ago
- OpenBeacon.org Active 2.4 GHz RFID tracking for nRF51822☆12Updated 10 years ago
- Arduino Libraries for LightwaveRF 433MHz rx and tx☆59Updated 5 years ago
- A MQTT to 433/315Mhz RF bridge build on the ESP8266 for home automation☆55Updated 7 years ago
- Terminal Shield for the WeMos D1 Mini with ESP8266☆21Updated 8 years ago
- Arduino sketch to read the status of up to 4 security sensors using End Of Line resistors and push events to MQTT☆39Updated 10 years ago
- This is now part of mirko/SonOTA - please no longer use this.☆10Updated 8 years ago
- ☆42Updated 8 years ago
- ESP8266 Momentary Switch with MQTT☆12Updated 8 years ago
- [OUTDATET] Arduino code sample to configure the ESP8266 via http and update Over-the-Air (OTA)☆20Updated 9 years ago
- A high level application for the Homie-esp8266 IoT framework☆39Updated 3 years ago
- Sketches for Arduino and attiny's☆19Updated 9 years ago
- Version 2 of the baseboard of Fleetwood - Home Automation Hub Controller☆19Updated 10 years ago
- Reads data from the DSC Keybus communication lines.☆27Updated 10 years ago
- Alternate firmware for the itead Sonoff based on the Arduino port of ESP8266☆35Updated 9 years ago
- Use the ESP8266 to control your home MiLights using the WiFi gateway bridge connected to the MiLights.☆10Updated 6 years ago
- Canny is a ESP8266 bridge replacement for Milight, Easybulb, Limitless and futlight clones using Muzzley☆27Updated 8 years ago
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 2 years ago
- Irrigation controller using Openhab and the ESP8266 module☆22Updated 9 years ago
- A python based service that receives sensor inputs and publishes them in various ways.☆108Updated last month
- ☆83Updated 2 months ago
- Power supply shield for the WeMos D1 Mini with ESP8266☆17Updated 7 years ago
- This program enables to: - receive MQTT data from a topic and send RF 433Mhz signal corresponding to the received MQTT data - publish…☆14Updated 8 years ago
- Control Zemismart lights and the Sonoff B1 via E131 (xlights or vixen)☆25Updated 5 years ago