sparkfun / MG2639_Cellular_ShieldLinks
An Arduino shield for the MG2639 Cellular and GPS module.
☆13Updated 7 years ago
Alternatives and similar repositories for MG2639_Cellular_Shield
Users that are interested in MG2639_Cellular_Shield are comparing it to the libraries listed below
Sorting:
- Breakout for SMD LED with built-in WS2811 controller IC.☆21Updated 6 months ago
- A PCB to combine four individual strain gauges or load sensors into the standard wheat bridge configuration and 4-color wiring found on l…☆10Updated 9 years ago
- SparkFun LED Driver Breakout -TLC5940☆13Updated 10 years ago
- Firmware library SparkFun's Photon Micro OLED Shield.☆10Updated 9 years ago
- Code and Documents for NodeMCU based relay board☆31Updated 7 years ago
- RepRap Electronics☆25Updated 14 years ago
- Hardware (Mainboard PCB designs etc.)☆18Updated 10 years ago
- SparkFun Low Current Sensor Breakout Board - ACS712☆18Updated 7 years ago
- WeMos RFM69 RF Gateway + IC2 Oled + ATSHA204☆25Updated 7 years ago
- Docker Buildbox for the ESP8266 WiFi chip☆15Updated 10 years ago
- Firmware library for the MAX17043 LiPo fuel gauge IC - used on SparkFun's Photon Battery Shield.☆15Updated 5 years ago
- A breakout and development board for the ESP8266 WiFi SoC.☆42Updated 5 years ago
- ESP8266 displaying mqtt messages on a Nokia 5110 LCD☆70Updated 9 years ago
- MPPT single-cell LiPo battery charger based on the LT3562☆34Updated 7 years ago
- 12A MPPT solar charge controller based on Arduino☆12Updated 9 years ago
- ESP8266-E12 Color Oled☆20Updated 9 years ago
- My code for controlling addressable LEDs with websockets - a work in progress...☆33Updated 6 years ago
- ESP8266-based, Blynk-compatible, beginner-friendly programmable WiFi development board.☆23Updated 5 years ago
- Hardware implementation for the esp8266-MQTT-io-node firmware☆23Updated 10 years ago
- Project to measure the capacity of an Alkaline battery using an Arduino☆66Updated 10 years ago
- The FemtoBuck is a small 6-36V 350mA constant-current LED driver, with analog or PWM dimmable control options.☆13Updated 3 years ago
- ESP32 IoT board with 4MB external RAM, 4MB external Flash, LiPo charger, external crypto engine USB-OTG☆51Updated last year
- ESP8285 Development Board☆55Updated 7 years ago
- Chinse Wifi rgbww controller module hack☆52Updated 9 years ago
- NodeMCU ESP8266 RF Gateway and Display Board☆117Updated 7 years ago
- SparkFun Transceiver RS-485 Breakout☆15Updated 9 years ago
- Generic library for any voltage and current sensors. Interrupt based, implements a zero cross detector and phase-locked loop for better p…☆27Updated 9 years ago
- How-to's and resources for upgrading NEJE desktop USB laser engravers☆26Updated 7 years ago
- WS2811/12 patterns for ATtiny85 + switch!☆56Updated 11 years ago
- (Deprecated attempt at) A Smoothie firmware port to the Smoothieboard v2 boards.☆34Updated 8 years ago