sparkfun / Blackberry_Trackballer_BreakoutLinks
The SparkFun BlackBerry Trackballer Breakout gives you easy access to a trackball which measures up, down, left, and right movements, clicks on the board, as well as adding a bit of flair to your project with four built-in LEDs.
☆27Updated 7 years ago
Alternatives and similar repositories for Blackberry_Trackballer_Breakout
Users that are interested in Blackberry_Trackballer_Breakout are comparing it to the libraries listed below
Sorting:
- Low Power Arduino Based (Smart)Watch☆88Updated 8 years ago
- ☆98Updated 9 years ago
- An (V)USB bootloader firmware for AVR-MCUs emulating the popular USBasp for programming itself☆185Updated 5 years ago
- Eagle CAD files for the Monochrome I2C OLED breakout board☆23Updated 3 years ago
- USB controlled OLED Display☆74Updated 3 years ago
- Board and library for Adns 3050 sensor☆89Updated 4 years ago
- 4 layer version of the Epi 32U4☆58Updated last year
- An HID keyboard sketch for the Arduino Nano 33 BLE☆24Updated 6 years ago
- Simple RPM-Meter☆57Updated 2 years ago
- ATMega32U4 Arduino board, available from SparkFun Electronics☆293Updated last year
- ☆98Updated 6 years ago
- TP4056 charger kicad schematics☆75Updated 3 years ago
- EagleCAD PCB files for Adafruit KB2040☆27Updated 3 years ago
- FT81x on ST7701S Arduino Driver☆59Updated last year
- Atmega32u4 Breakout Board☆90Updated 6 years ago
- Component Tester in a Keychain☆75Updated 3 years ago
- EagleCAD PCB files for the Adafruit Feather ESP32-S3.☆28Updated last month
- Firmware images for Adafruit's Bluefruit LE Modules (Bluefruit LE Friend, etc.)☆121Updated 6 years ago
- IR Remote Receiver and Decoder☆49Updated 2 years ago
- USBasp for ATtiny85☆33Updated 3 years ago
- This repository lists the complete source code to drive a Sharp Memory LCD with Arduino☆102Updated 7 months ago
- Hot air rework controller for generic 858D / 8586 / 8858 / 852 / 878 / 858 hot air guns from China.☆31Updated 5 years ago
- A standalone programmer for mass-programming AVR chips☆86Updated 4 years ago
- Single-Cell Li-Ion Battery Charger with Monitoring☆66Updated 2 years ago
- A KiCad project for esp-wroom-32 and breadboard.☆53Updated 6 years ago
- 2D actuator☆30Updated 6 years ago
- Arduino core for nRFMicro, SuperMini nRF52840, and nice!nano v2 boards.☆57Updated last year
- SparkFun libraries converted for use in KiCAD!☆80Updated 9 years ago
- Simple USB Power Tester☆55Updated 2 years ago
- A SAMD21G18 based easy to solder module.☆74Updated 6 years ago