smartavionics / CuraEngine
CuraEngine is a powerful, fast and robust engine for processing 3D models into 3D printing instruction for Ultimaker and other GCode based 3D printers. It is part of the larger open source project called "Cura".
☆12Updated this week
Alternatives and similar repositories for CuraEngine:
Users that are interested in CuraEngine are comparing it to the libraries listed below
- Customized U8glib for use in Marlin 2.0☆47Updated 9 months ago
- An Arduino Shield for 3D printers☆18Updated 5 years ago
- Hardware information for the Duet 3 Mainboard 6HC☆44Updated last year
- Marlin-based Laser Cutter/Engraver firmware for RepRap Hardware ( Marlin 1.0.0 )☆29Updated 8 years ago
- ESP32 DIY Digital Readout☆89Updated 5 years ago
- ☆55Updated 3 years ago
- ☆19Updated 2 years ago
- Adapter to use RS-232 Magellan/SpaceMouse with modern software☆40Updated last year
- An arduino based adapter to drive a 20x4 line parallel or i2c panel from smoothieware☆23Updated 8 years ago
- Probe Wizard for Mach3☆30Updated 5 years ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆48Updated 3 years ago
- List of controllers supported by grblHAL☆39Updated last month
- A Serial Terminal for FluidNC☆21Updated 2 years ago
- MKS RUMBA32 is modified in Aus3D RUMBA32 version and a powerful 32-bit 3D printer control board with STM32F446VET6 , The main frequency i…☆16Updated 3 years ago
- 3D printer control board based on ESP32,support 8 Driver motors.☆74Updated 2 years ago
- A powerful 32-bit 3D printer control board.☆69Updated 4 years ago
- ☆74Updated 2 years ago
- Experimental grblHAL post processor with canned cycles and 4th axis support☆16Updated 11 months ago
- Configuration: CFG/SPI microsteps: Up to 1/256 microPlyer: 1/256 Logic Voltage VI0: 3-5V Motor Voltage : 5.5-46V Motor Phase Current…☆14Updated 5 years ago
- SMuFF Hardware Interface Firmware☆10Updated 4 years ago
- A cheap DIY selfmade 3D-Mouse to use in Solidworks☆32Updated 8 years ago
- fully 3D printable CAD-Mouse☆31Updated 10 years ago
- CNC Shield for Arduino DUE powered with Synthetos G2 ( https://github.com/synthetos/g2 )☆15Updated 9 years ago
- G-code post-processor to make 3d-printer travel moves along Bezier curves☆26Updated 9 years ago
- Pendants for controlling FluidNC CNC firmware☆35Updated 7 months ago
- 3D printer / slicing GUI built on top of the Uranium framework☆33Updated 4 years ago
- DIY CNC Automatic Toolchanger☆63Updated 6 years ago
- A Pendant for FluidNC CNC Firmware☆36Updated 3 weeks ago
- A Grbl_ESP32CNC Controller for MPCNC☆87Updated 2 years ago
- The RAMPS 1.6 is the second RAMPS iteration released by BIGTREETECH. It replaces the original green power connector with a pair of screw …☆87Updated 4 years ago