DzikuVx / camera_sliderLinks
☆20Updated 2 years ago
Alternatives and similar repositories for camera_slider
Users that are interested in camera_slider are comparing it to the libraries listed below
Sorting:
- Extend the possibilities of cheap digital power supplies with a WiFi module☆60Updated last year
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆27Updated 2 years ago
- Semi-automatic passive printable/castable feeder for LitePlacer☆59Updated 5 years ago
- A simple LED driver for Remote Control Cars, Planes, Multicopters and everything in between☆33Updated 2 years ago
- ☆10Updated 2 years ago
- Reflow controller with ESP32 and TFT LCD on board.☆69Updated 7 months ago
- An ATTiny version of Julian Iletts PWM5 Solar Charge Controller☆50Updated 4 years ago
- Sailor Hat for Raspberry Pi hardware design files☆53Updated last year
- An Arduino 2.4GHz and IR remote controller with OLED display☆146Updated 4 years ago
- An Atmega328P based 2.4GHz receiver with integrated TB6612FNG motor driver. PWM and SBUS outputs.☆152Updated last year
- Source code and other files for reading values from digital calipers. See the project page for complete write up at http://makingstuff.in…☆40Updated 9 years ago
- A very simple menu system using an oled and rotary encoder☆57Updated last year
- Lixie II - Open Source Hardware files!☆41Updated 5 years ago
- Speed controller and receiver for small robots☆57Updated 7 months ago
- ESP32 Pco D4 project with 0.66" Oled Display☆54Updated 7 years ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆131Updated 4 years ago
- Reflow Oven Controller with EPS32 and Webapp☆45Updated 6 years ago
- ☆73Updated 3 years ago
- Sparklines 📉📈 for ESP8266, ESP32 – Should work with other Arduino-supported controllers☆96Updated 4 years ago
- ☆12Updated 6 years ago
- ☆13Updated 4 years ago
- Arduino project to upgrade cheap Hobbyking HK-T6A or Flysky FS-CT6B transmitters or any other old RC TX☆62Updated 7 years ago
- ☆109Updated 2 years ago
- ☆32Updated 4 years ago
- ☆57Updated last year
- Is it magik? Or is it just a 3d printed box for holding your solder stencils with automatic lifting and vacuum hold down?☆35Updated 4 years ago
- The VFD Collective shared projects☆22Updated 3 months ago
- A CNC controller to use and test Grbl_ESP32☆79Updated 5 years ago
- WakeUp Alarm based on ESP32☆44Updated 6 years ago
- RC Transmitter using ESP32 and Semtech SX1280☆53Updated 9 months ago