rahulsarchive / 4AxisFoamCutterLinks
An open-source DIY 4 Axis Foam cutter using Ramps + Arduino for cutting RC Wing Cores.
☆95Updated 4 years ago
Alternatives and similar repositories for 4AxisFoamCutter
Users that are interested in 4AxisFoamCutter are comparing it to the libraries listed below
Sorting:
- A CNC controller to use and test Grbl_ESP32☆80Updated 5 years ago
- Buildbotics CNC, 3D printer and other machine controller☆49Updated 3 years ago
- cn5X++ is a new 5/6 axis Grbl control panel to implement all the grbl-Mega-5X capabilities.☆83Updated last year
- ☆77Updated 3 years ago
- List of controllers supported by grblHAL☆62Updated last month
- ☆53Updated 2 years ago
- DIY CNC Automatic Toolchanger☆72Updated 7 years ago
- A Grbl_ESP32CNC Controller for MPCNC☆91Updated 3 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆81Updated 6 months ago
- ESP32 DIY Digital Readout☆110Updated 6 years ago
- Position control of DC motors☆331Updated last year
- Adapter board to use a Raspberry Pi as a Linux CNC controller☆61Updated 3 years ago
- Arduino-based CNC Plasma torch system Torch Height Controller☆84Updated 10 years ago
- ☆19Updated 8 years ago
- Repository for uStepper☆100Updated 6 years ago
- 4 axis CNC, 3D, Laser Controller☆65Updated last year
- An Atmega328P based 2.4GHz receiver with integrated TB6612FNG motor driver. PWM and SBUS outputs.☆152Updated last year
- Arduino based THC that read plasma cutter voltage and send Up and Down signals to Plasma Torch Actuator to adjust voltage to target value…☆50Updated 4 years ago
- Firmware for Replicape☆37Updated 3 years ago
- Tiva C BoosterPack for GRBL MPG/DRO☆47Updated 11 months ago
- LinuxCNC Features☆60Updated 10 years ago
- ☆80Updated last year
- Project for building a cheap galvo laser system using Stepper motors and widely available parts.☆57Updated 2 years ago
- Low cost servo drive for small CNC machinery☆54Updated 9 years ago
- Professional grade, 100% GRBL compatible motion control firmware for the ESP32☆70Updated 2 weeks ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆54Updated 4 years ago
- A powerful 32-bit 3D printer control board.☆74Updated 5 years ago
- Closed Loop Motor Controller☆135Updated 4 years ago
- Creates a dedicated CNC machine control with professional features from commodity x86-based hardware☆21Updated 7 years ago
- uStepper Robot Arm STL files and instruction Revision 3☆94Updated 8 years ago