ra6070 / BLE-TPMSLinks
ESP32 BLE Tire Pressure Management System
☆118Updated 5 years ago
Alternatives and similar repositories for BLE-TPMS
Users that are interested in BLE-TPMS are comparing it to the libraries listed below
Sorting:
- Decode tire pressure monitoring system TPMS BLE 433MHz CC1101 ESP8266 ESP32☆113Updated 2 weeks ago
- Experimental - OBD2 to feed custom device via bluetooth☆93Updated last year
- A WEB Based OBDII Dongle Platform using the ESP32 WROVER Module☆365Updated 2 years ago
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆350Updated 3 weeks ago
- ESP32 based CAN development board☆183Updated 3 years ago
- Arduino ESP32 library supporting the on-chip CAN module☆361Updated 10 months ago
- M5Stack Tough (ESP-32) Sailing Instruments Display and Autopilot Control☆121Updated 11 months ago
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆65Updated 2 months ago
- DIY bluetooth obd2 gauge with ESP32 (CYD)☆401Updated 3 months ago
- Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display☆123Updated last year
- Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3☆36Updated last year
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆117Updated last year
- ☆67Updated last year
- Arduino project to control webasto heater via W-bus☆55Updated 7 years ago
- Library for working with JBD BMS☆76Updated last year
- ☆143Updated 2 years ago
- ☆42Updated 5 years ago
- An Arduino library for reading OBD-II data from your car over CAN bus☆57Updated 2 years ago
- Wifi to 3x Serial bridge based on a ESP32☆90Updated last year
- ☆152Updated 2 weeks ago
- A ESP32 based CAN interface for your webbrowser☆27Updated 4 years ago
- An ESP32 CAN 2.0B library☆74Updated 7 months ago
- OBD2 K-line Reader (ISO9141 and ISO14230) with microcontrollers like ESP32, Arduino☆170Updated last week
- Car OBD gauges Arduino TFT☆25Updated last year
- A ESP32 based interface between CAN-bus and IoT environments.☆47Updated 2 years ago
- ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).☆33Updated 2 years ago
- ☆33Updated 3 years ago
- Read and Write Library for Overkill Solar BMSs☆19Updated 3 years ago
- ESP32 and ESP32-S3 board with CAN interface, runs on 12V power (with auto shutdown)☆716Updated 2 months ago
- Firmware for canbus boxes☆113Updated 6 months ago