prototux / headunit-uiLinks
A head unit UI designed to replace the RTx/SMEG/RNEG/NG4/RCC/NAC
☆19Updated 3 years ago
Alternatives and similar repositories for headunit-ui
Users that are interested in headunit-ui are comparing it to the libraries listed below
Sorting:
- VAN - CAN protocol bridge (V2C) for cars made by PSA Group (Peugeot, Citroen)☆143Updated last week
- Arduino sketch to operate new PSA/Stellantis (Peugeot, Citroen, DS, Opel) comfort devices (CAN2010) on old BSI CAN-BUS (CAN2004)☆66Updated last month
- Work☆29Updated 8 years ago
- PSA (Peugeot/Citroen/DS) electronics architecture reverse engineering.☆85Updated last month
- PSA NAC / RCC Arduino Diagbox Configuration software☆39Updated 4 years ago
- PSA/Stellantis (Peugeot, Citroen, DS, Opel) NAC / RCC / CIROCCO Configuration softwares - Telecoding / Calibration☆96Updated last week
- A simple WiFi portal to control the display in your Peugeot or Citroen if you remove the factory installed head unit☆31Updated 3 years ago
- Firmware for canbus boxes☆105Updated last month
- Peugeot Citroën CAN bus☆89Updated 2 years ago
- Arduino sketch to send UDS / KWP diagnostic frames over CAN-BUS to PSA/Stellantis cars (Peugeot, Citroen, DS, Opel)☆176Updated 2 months ago
- ESP32 based steering wheel adapter for Peugeot and Citroen cars☆36Updated 5 years ago
- Reverse engineering Volkswagen car radios☆106Updated 5 months ago
- This is an effort to reverse engineer mostly the software side of the SMEG+ units from PSA but also to interface with the hardware in the…☆16Updated 4 years ago
- Continental OVIP firmware reverse engineering for PSA/Stellantis cars (Peugeot, Citroen, DS, Opel)☆148Updated 10 months ago
- PSA/Stellantis (Peugeot, Citroen, DS, Opel) Seed/Key Algorithm to unlock ECUs configuration and download☆84Updated 4 months ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆113Updated 3 years ago
- An Arduino library to remote control Junsun Android 8227l head unit☆54Updated 4 years ago
- Reads VW/Audi specific measuring blocks over an OBD-II port using an ELM327 adapter☆112Updated 4 years ago
- Arduino sketch to retrieve data from a Peugeot's CAN bus☆100Updated 8 years ago
- A modular, open-source vehicle diagnostic and infotainment system.☆106Updated last week
- Open Source VBF edit and flash tool☆60Updated 4 years ago
- Schematic, PCB and source code for a small Arduino-based controller to make Ford FDIM dash display useful again☆41Updated 4 years ago
- Volvo central electronic module pin cracker via OBD for P1, P2 and P3 platforms☆135Updated last year
- Parses and extracts flash binaries from Mercedes CFF flash files☆26Updated 10 months ago
- Vehicle Area Network (VAN) bus packet reader/writer for ESP8266 and ESP32☆60Updated this week
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆116Updated 10 months ago
- Fulcrum is the ultimate J2534 DLL Shim written in C++ which is able to pipe data out from the native calls to any other location for supe…☆33Updated 6 months ago
- SMEG+ Unit reverse engineering☆44Updated 4 years ago
- Library and applications to work with Dаіmlеr diagnostics CBF files.☆151Updated last month
- ☆14Updated 5 years ago