pololu / pololu-usb-avr-programmer-v2
Pololu USB AVR Programmer v2 software.
☆14Updated 2 months ago
Alternatives and similar repositories for pololu-usb-avr-programmer-v2:
Users that are interested in pololu-usb-avr-programmer-v2 are comparing it to the libraries listed below
- Example code and description how to use ESP32 low noise amplifier (LNA), including Arduino library and ESP-IDF component☆53Updated 5 years ago
- Hardware of Jasper's Electronic Load R2☆21Updated 6 years ago
- Adafruit TFT library using 8 bit parallel access ported to STM32☆49Updated 5 years ago
- Example projects for the 1BitSy development boards.☆38Updated last year
- STk500v2 bootloader for AVR 2560 and otherchips☆46Updated 2 years ago
- DMA helper/wrapped for ATSAMD21 such as Arduino Zero & Feather M0☆60Updated last year
- Espressif ESP32 driving a controller-less monochrome lcd with parallel I2S bus☆64Updated 5 years ago
- USBasp - USB programmer for Atmel AVR controllers (with WinUSB support)☆37Updated 9 months ago
- 1-Wire protocol library for ATTiny85 microcontroller☆33Updated 9 years ago
- ☆19Updated 6 years ago
- simple and cheap 16 channel logic analyzer based on Cypress CY7C68013A development board☆33Updated 4 years ago
- program your stm8 devices with SWIM/stlinkv(1,2)☆11Updated 4 years ago
- Femto ESP32 Micro USB☆33Updated 3 years ago
- Arduino driver for 4-bit controllerless graphics LCD☆29Updated 5 years ago
- PC tool for uplading hexfiles to the STM8 microcontroller via UART or SPI , using the built-in ROM bootloader. Works under Windows and Po…☆82Updated 3 months ago
- Experiments with a 9-character 16-segment alphanumeric LCD☆10Updated 3 years ago
- Atmel megaAVR: development platform for PlatformIO☆29Updated 10 months ago
- TinyUSB-based logic analyzer code for Sigrok☆27Updated 3 years ago
- Notes on using the Chinese "SAMD21-M0-Mini" board☆54Updated 2 years ago
- Sensything is an ESP32-based IoT device that has multiple sensor interfaces to read from and send data from both analog and digital senso…☆20Updated 5 years ago
- Native Python library for accessing USBTMC test equipment☆39Updated 14 years ago
- Bus Pirate NG firmware and hardware☆39Updated 2 years ago
- Arduino Power Management Library for nRF5x☆43Updated 6 years ago
- port of free-DAP to standalone arduino☆77Updated 3 months ago
- DIY portable Wi-Fi enabled signal generator☆42Updated 4 years ago
- Open-Source Oscilloscope based on STM32F3-DISCOVERY board☆33Updated 3 years ago
- USB HID Data Gateway☆53Updated 4 years ago
- Hardware of Jasper's Electronic Load R3☆25Updated 6 years ago
- Serial bootloader for STM8 microcontrollers☆96Updated 5 years ago
- There are two 'versions' of the LCD library - one is straightup avr-gcc and the other is an Arduino Library. They're essentially the same…☆106Updated last year