palachzzz / xiaoxiang2ninebot_bms_protocol_converterLinks
Xiaoxiang BMS <=> Ninebot Z converter
☆17Updated last year
Alternatives and similar repositories for xiaoxiang2ninebot_bms_protocol_converter
Users that are interested in xiaoxiang2ninebot_bms_protocol_converter are comparing it to the libraries listed below
Sorting:
- Xiaomi M365 compatible, open source firmware for ATMega328p+BQ769x0 BMS. Ninebot in proto_test branch☆205Updated 4 years ago
- ☆62Updated 6 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆71Updated last year
- Library for working with JBD BMS☆73Updated last year
- Arduino library for communicating with Daly BMSs over UART☆110Updated last year
- Software, hardware and protocol information for the Eltek Flatpack2.☆50Updated 6 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆112Updated 10 months ago
- SMBUS analyzer tool using an Arduino Pro Mini for Smart Batteries that use the Smart Battery System Specification.☆30Updated 6 years ago
- Collected documents and software from DALY☆21Updated 6 months ago
- Arduino code to read Smart Battery data from laptop battery packs using SMBus/I2C☆114Updated 10 years ago
- Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters☆65Updated 2 years ago
- A linux software to control ZTE Tech EBC A-series battery testers and electronic loads☆26Updated 2 years ago
- Custom BMS for Ninebot/Xiaomi Scooters☆14Updated last year
- Xiaomi/Ninebot electric scooters internals documentation☆124Updated 6 years ago
- ☆30Updated 3 years ago
- M365_MC_WB☆137Updated last year
- Copy of SF hosted libwbus (not ours - for safekeeping!)☆18Updated 9 years ago
- ☆81Updated last year
- Converts the JK-BMS RS485 data to Pylontech CAN data☆87Updated 3 months ago
- Wifi to 3x Serial bridge based on a ESP32☆78Updated 10 months ago
- ☆11Updated 3 years ago
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆27Updated 4 years ago
- Program for reading data from a Xiaoxiang smart BMS and printing to an OLED display☆21Updated 4 years ago
- Use an ESP32 or STM32 to send commands to Ninebot BMS and remove the 19A current restriction.☆10Updated 11 months ago
- MPPT hardware which uses FUGU firmware☆20Updated 2 years ago
- Software for the Pedelec/E-Bike controller based on Arduino hardware, see www.pedelecforum.de "ForumsController"☆86Updated 4 years ago
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆54Updated 6 months ago
- ESP32 based CAN development board☆175Updated 3 years ago
- Read and Write Library for Overkill Solar BMSs☆17Updated 2 years ago
- Vesc UART <-> Esp32 Wifi bridge☆16Updated 5 years ago