open-electronics / LoRa
LoRa library for Arduino
☆32Updated 6 years ago
Related projects: ⓘ
- ☆20Updated this week
- Raspberry PI Lora Gateway/Node for RFM92/95/96/98/69HCW Modules☆60Updated 7 years ago
- An ESP8266 based Gateway for sending LORA transmissions to the Habitat high altitude balloon tracking system.☆25Updated 6 years ago
- Source code for single-channel LoRaWAN Gateway based on LoRaGo DOCK (ESP8266 and SX1276)☆33Updated 4 years ago
- ESP32+RFM95 = Single-channel LoRa WiFI Gateway (or device!)☆28Updated last year
- Arduino compatible single cell ultra low power LoRaWAN node☆20Updated 6 years ago
- SAMD21 Development Board with LoRa and GPS☆35Updated 5 years ago
- Application example to send both Sigfox and LoraWAN messages using Murata module☆11Updated 2 years ago
- RAKwireless,RAK811,BreakBoard,GPS tracker,Low power,Open source☆5Updated 2 years ago
- datasheet and Arduino demo code for LoRa Radio Node v1.0☆46Updated 6 years ago
- SX1301 Lora Concentrator Raspberry PI based gateway setup☆76Updated 2 years ago
- Breakout board for LoRa all-in-one module CMWX1ZZABZ☆12Updated 4 years ago
- AcSIP S7XG LoRaWAN/GPS module library☆26Updated 5 years ago
- BasicMAC LoRaWAN stack that supports (but is not limited to) Arduino☆76Updated 3 years ago
- ☆63Updated this week
- A low budget battery powered LoRa node to smart up your city☆31Updated 6 years ago
- SX1278 433Mhz Ra-02 01☆29Updated 6 years ago
- Version 5 of Single Channel LoRa Gateway☆61Updated 3 years ago
- RAK811_BreakBoard for platformio from https://github.com/RAKWireless/RAK811_BreakBoard☆23Updated 4 years ago
- "IoT Made Easy!" - Control SAM R34 or WLR089U0 Module with ASCII command set over UART☆18Updated 2 years ago
- Driver/HAL to build a gateway using a concentrator board based on Semtech SX1301 multi-channel modem and SX1257/SX1255 RF transceivers.☆24Updated 6 years ago
- STM32 and AVR128 Printed Circuit Board for creating IOT nodes with the RFM95 LORA chip☆16Updated 2 years ago
- 1-channel gateway based on ESP8266 mcu☆65Updated 6 years ago
- Sketches for the NEXUS board for RFM95W (RFM92W, RFM98W)☆35Updated 8 years ago
- Lora board with Arduino nano compatibile pinout and simple battery management☆35Updated 5 years ago
- ESP8266 and sx1276 LoRaWan☆13Updated 6 years ago
- Example code and description how to use ESP32 low noise amplifier (LNA), including Arduino library and ESP-IDF component☆51Updated 4 years ago
- LoRaWAN Gateway for Raspberry Pi☆18Updated 3 years ago
- ☆29Updated 8 years ago