mmind / mali-driverLinks
Installer for mali drivers. Similarly to the flashplugin, the mali userspace binaries are generally not redistributable. So this installer grabs the archive from a suitable source, displays the license and then moves everything in its correct place.
☆16Updated 10 years ago
Alternatives and similar repositories for mali-driver
Users that are interested in mali-driver are comparing it to the libraries listed below
Sorting:
- ☆92Updated 6 years ago
- A PCB for attaching an iPad retina LCD to a DisplayPort source☆199Updated 12 years ago
- An Psion to USB keyboard controller☆52Updated 3 years ago
- A reverse-engineered USB 3.0 to eMMC adapter board for the Genesys Logic GL3224☆23Updated 7 years ago
- A firmware-only half-duplex 10Base-T implementation for AVRs☆134Updated last year
- DIY BIOS POST Card with the Raspberry Pi Pico over the LPC bus☆87Updated 3 months ago
- Project to talk to IDE interface using Raspberry-Pi GPIO pins in SMI (Secondary Memory Interface bus) mode☆63Updated 8 years ago
- Use the ch32v003 as a usb pd controller☆48Updated last year
- Drive an old laptop display from an 8-bit AVR microcontroller☆20Updated 10 years ago
- Reverse engineering of WEB-PDC001 protocol☆13Updated 6 years ago
- An open source HD audio DAC☆64Updated 10 years ago
- Flashing Pano Logic thin clients without a programmer☆42Updated 3 years ago
- Raw DPI for Raspberry-Pi B+☆22Updated 10 years ago
- Linux kernel driver for PATA bit-banging over GPIOs☆176Updated 5 years ago
- A opensource PCIe 3.0 Hub design based on ASM2806 with Raspberry Pi 5's PCIe FPC connector design☆86Updated last year
- Pano Logic G2 Reverse Engineering Project☆146Updated 4 years ago
- Ultra low cost HDMI-USB Video Acquisition (HDMI Capture Card) based on MS2109☆58Updated 3 years ago
- Chip support package for Cypress EZ-USB FX2 series microcontrollers☆83Updated last week
- Blob-free logic analyzer firmware for FX3☆87Updated 2 years ago
- Firmware for Raspberry Pico to work as JTAG debugger using OpenOCD☆72Updated 10 months ago
- Realtek RTD2660/2662 programmer☆119Updated 8 years ago
- A PCB for putting a Raspberry Pi CM4 inside a 1st-generation iPad.☆62Updated 2 years ago
- MXM to PCIe adapter☆61Updated last year
- Library routines for creating firmware for the Cypress FX2 (CY7C68013 and variants) with SDCC☆148Updated last year
- source code for RTD2662☆74Updated 9 years ago
- S/PDIF receiver library for Raspberry Pi Pico series☆99Updated 8 months ago
- ☆77Updated 10 years ago
- Raspberry Pi hat to test Vaio P displays☆21Updated last year
- Audio out with an FTDI UART cable☆43Updated 4 years ago
- Arduino on a mini-PCIe card☆100Updated 10 years ago