malebuffy / Wanhao-Duplicator-I3-Autoleveling-Without-SDCardLinks
Repetier Firmware for the Wanhao Duplicator i3 with Bed Leveling enabled with an Inductive z probe at the z min position
☆11Updated 8 years ago
Alternatives and similar repositories for Wanhao-Duplicator-I3-Autoleveling-Without-SDCard
Users that are interested in Wanhao-Duplicator-I3-Autoleveling-Without-SDCard are comparing it to the libraries listed below
Sorting:
- DIY Romba Virtual Wall with Atmega 328P Processor + IR LED☆116Updated 3 years ago
- ESP32 DIY Digital Readout☆99Updated 5 years ago
- 3D Printed Wall-Mounted NeoPixel LED Clock with NTP Synchronization☆55Updated last year
- Analog clock that syncs with NTP via ESP8266☆28Updated 6 years ago
- An open-source lost-model alarm for RC drones and airplanes☆13Updated 6 years ago
- The Little Stick Welder with Big Features.☆43Updated 3 years ago
- A water detector to prevent flooding that runs on LiPO batteries and transmits its status and notifications via MQTT☆69Updated 6 years ago
- a fork of Marlin firmware (bugfix-1.1.x) for the Monoprice MP Mini Delta 3d printer☆76Updated this week
- A hardware remote for Octoprint controlled 3D Printers☆21Updated 6 years ago
- IoT smart gas meter gets your home gas consumption nicely charted on a web page. Build your own for less than 10€☆55Updated 2 years ago
- Adds RGB LED support to OctoPrint with the ability to choose effects based on the current status of your printer☆33Updated 4 years ago
- Web UI for Monoprice Select Mini 3D Printer☆64Updated 3 years ago
- Hugo is a 4-button ESP8266 Wi-Fi Remote, Arduino compatible and simple to use.☆112Updated 2 years ago
- Fork of MarlinFW for use with Monoprice Mini Delta☆71Updated 5 years ago
- Creates an access point and allows the user to change the name and password remotely☆39Updated 6 years ago
- Library for use with Arduino compatible micro controllers (web enabled) to access the Octoprint API on Raspberry Pi's running the Octopri…☆45Updated 2 years ago
- Arduino/Marlin firmware flasher for OctoPrint☆40Updated last year
- ☆170Updated 5 years ago
- Some g-code post-processors for 3D printing. This repository hosts the "famous" wood pattern.☆137Updated 3 years ago
- ☆126Updated 2 years ago
- ☆64Updated 3 months ago
- Project of device that allow to use lithium batteries in Roomba without Charging Error 5☆22Updated 5 years ago
- A Ryobi Battery Conversion for Ride on Cars☆68Updated last year
- ☆101Updated 4 years ago
- WiFi Controlled Desk Lamp☆60Updated 4 years ago
- ☆59Updated 2 years ago
- Hardware and Software for a Raspberry UPS based on an ATTiny☆65Updated 2 years ago
- A simple LED driver for Remote Control Cars, Planes, Multicopters and everything in between☆33Updated 2 years ago
- MKS TFT32/28 alternative firmware☆68Updated 7 years ago
- Sketch for NodeMCU boards to render boblight/hyperion with a fallback to MQTT☆19Updated 6 years ago