kantlivelong / OctoPrint-GCodeSystemCommandsLinks
Define G-Code commands that execute local system commands.
☆37Updated 3 years ago
Alternatives and similar repositories for OctoPrint-GCodeSystemCommands
Users that are interested in OctoPrint-GCodeSystemCommands are comparing it to the libraries listed below
Sorting:
- Adds RGB LED support to OctoPrint with the ability to choose effects based on the current status of your printer☆33Updated 4 years ago
- ☆23Updated last month
- ☆19Updated 5 years ago
- ☆44Updated 2 years ago
- Plugin for OctoPrint - saves filename, print time and filament usage for each print☆64Updated 9 months ago
- Plugin for OctoPrint - displays temperatures on navbar☆45Updated 9 months ago
- Perform actions, send gcode or system commands on OctoPrint with buttons connected to gpio pins☆35Updated 9 months ago
- Smart control of your power supply via GPIO, GCODE Command, System Command, or variety of sub-plugins.☆211Updated last year
- An OctoPrint Plugin that adds support for MQTT.☆162Updated 11 months ago
- ☆48Updated last year
- Slic3r plugin for slicing within OctoPrint☆91Updated 2 years ago
- ☆30Updated last month
- OctoPrint plugin that intercepts M150 GCode commands and controls local GPIOs connected to LEDs.☆64Updated 5 years ago
- What could be better than using OctoPrint or WLED? A plugin to use both!☆62Updated 10 months ago
- ☆110Updated 4 months ago
- PrusaSlicer packaged in a ARM AppImage. Pre-built AppImages located within releases.☆61Updated this week
- OctoPrint-Plugin☆12Updated 5 years ago
- A hardware remote for Octoprint controlled 3D Printers☆21Updated 6 years ago
- MPCNC posts processor for Fusion 360 and Marlin☆63Updated 3 years ago
- ☆63Updated last month
- ☆120Updated last month
- Library for use with Arduino compatible micro controllers (web enabled) to access the Octoprint API on Raspberry Pi's running the Octopri…☆44Updated 2 years ago
- A plugin for editing the EEPROM data of Marlin Firmware, from within OctoPrint.☆35Updated 9 months ago
- Mini Delta Bootloader☆25Updated 5 years ago
- Testing and calibration objects/gcodes.☆33Updated 5 years ago
- ☆107Updated last week
- ESP32 DIY Digital Readout☆96Updated 5 years ago
- Arduino/Marlin firmware flasher for OctoPrint☆39Updated last year
- A script to move an existing OctoPrint install from Python 2 to Python 3☆62Updated last year
- Plugin for automatically shutting down the system after print is finished☆18Updated 3 years ago