jomjol / neural-network-autotrain-digital-counter
☆21Updated 2 years ago
Alternatives and similar repositories for neural-network-autotrain-digital-counter
Users that are interested in neural-network-autotrain-digital-counter are comparing it to the libraries listed below
Sorting:
- ☆11Updated last month
- ☆62Updated this week
- ☆67Updated 3 years ago
- ☆192Updated 3 years ago
- Training and using a neural network to read out the value of an analog display - example including small node server for demonstration☆47Updated last week
- ☆12Updated 3 years ago
- ☆101Updated last year
- Interact with Zehnder Comfoair with esp32☆132Updated 10 months ago
- Firmware for ESP8266 allowing eBUS communication for ebusd (https://github.com/john30/ebusd)☆154Updated 11 months ago
- ESP8266/ESP32 decrypts wireless MBus frames from a Multical21 water meter☆103Updated last year
- Reads gasmeter☆12Updated 2 years ago
- PV Inverter solar dashboard using m5paper (e-Ink display)☆12Updated 2 years ago
- ☆44Updated 3 years ago
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆102Updated last month
- Data provider for smartmeter watermeter.☆224Updated last month
- DIY Zigbee CC2530 Motion sensor (AM312/ AM412/ BS312/ BS412), Temperature /Humidity /Pressure sensor (BME280), Ambient Light sensor (BH17…☆54Updated 6 months ago
- A tool for integrating Growatt Noah 2000 home batteries with Home Assistant via MQTT, enabling monitoring and control of your energy stor…☆106Updated last week
- Plant Watering Sensor Project for Zigbee Network (in the beginning it was based on the Source Code of theDIYRUZ Flower Project - https:/…☆166Updated this week
- WiFi Based Sprinkler Controller using an ESP8266 and esphome☆23Updated 6 years ago
- Easy to use device for connecting "old" measuring units (water, power, gas, ...) to the digital world☆7,116Updated this week
- Custom component for retrieving sensor information from Weishaupt WEM Portal☆57Updated 2 months ago
- Growatt ShineWifi modbus with ESPHome code to run native in Home Assistant☆32Updated 10 months ago
- Issue Tracker for ESPHome☆308Updated 4 months ago
- Multiple phase DIY energy consumption monitor using ESP32 and ESPHome☆183Updated 2 weeks ago
- Single relay with ds18b20 sensor for TI cc2530 and Sonoff Zigbee☆64Updated last year
- Github for hosting the documentation for the project: https://github.com/jomjol/AI-on-the-edge-device☆93Updated this week
- ESP32 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆735Updated 3 weeks ago
- Manual for the BSB-LAN Hard- & Software☆10Updated 11 months ago
- Tasmota unofficial firmware builds. Install via Tasmota WebInstaller☆102Updated this week
- Esphome component for Deye 3 phase inverters for Home Assistant☆166Updated 5 months ago