henryk / openmiliLinks
Open implementation of the Mi-Light 2.4GHz LED light control protocol
☆106Updated 8 years ago
Alternatives and similar repositories for openmili
Users that are interested in openmili are comparing it to the libraries listed below
Sorting:
- My personal Workspace for Mysensors HW☆34Updated 5 years ago
- Melvanimate☆60Updated 7 years ago
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- Control Roomba with esp8266 webinterface and simple API☆124Updated 7 years ago
- ESP8266 / H801 RGB controller using MQTT and WiFi onboarding☆30Updated 2 months ago
- Chinse Wifi rgbww controller module hack☆51Updated 8 years ago
- ☆43Updated 9 years ago
- ESP8266 based bidirectional bridge between MQTT and IR (change MQTT message to IR signal and change received IR signal to MQTT message)☆145Updated 4 years ago
- Arduino library for MiLight and Limitless led bulbs control using a LYT/WiFi shield or a PL1167 pcb module☆25Updated 6 years ago
- ESP8266-based smart wall switch☆133Updated 7 years ago
- Battery powered door and window sensor with ultra low standby power. Arduino, ESP-12, Reed switch, ATtiny, LDO☆172Updated 8 years ago
- Itead Studio SonoffSC custom firmware with MQTT and Domoticz support☆102Updated 5 years ago
- Alternate firmware for the itead Sonoff based on the Arduino port of ESP8266☆34Updated 8 years ago
- nodejs modul with protocol support for different 433mhz switches and weather stations for the RFControl Arduino library.☆49Updated 2 years ago
- Homie based bridge between MQTT and RFlink module☆22Updated 5 years ago
- Bridge from RFLink to an mqtt broker using ESP8266 programmed with arduino IDE☆38Updated 7 years ago
- Provide ESP32 with Web, MQTT and OTA firmware using Arduino IDE or PlatformIO☆71Updated 7 years ago
- RF433Mhz decoding library☆61Updated 2 years ago
- Projet d'afficheur domotique à base d'une matrice de LEDs, d'un NodeMCU(ESP8266) avec Arduino☆60Updated 8 years ago
- ☆42Updated 7 years ago
- Random☆20Updated 5 years ago
- Xiaomi Zigbee to MQTT bridge using zigbee-shepherd☆99Updated 6 years ago
- Some nodemcu based to run sonoff wifi enabled plugs through MQTT☆46Updated 5 years ago
- Canny is a ESP8266 bridge replacement for Milight, Easybulb, Limitless and futlight clones using Muzzley☆27Updated 8 years ago
- ☆23Updated 7 years ago
- MiniESP for ESP01 and modules with few pins, enables GPIO 1/3 disables Serial output.☆29Updated 8 years ago
- MY9291 LED driver library for Arduino ESP8266☆25Updated 7 years ago
- Plugin for a rapid development of battery-powered sensors☆131Updated 2 years ago
- Custom hardware designs for a super tiny $5 WiFi (RGB enabled) LED dimmer module based on the ESP8266☆169Updated 7 years ago
- 433mhz rf sniffer and receiver☆119Updated 3 years ago