djsb / cannyLinks
Canny is a ESP8266 bridge replacement for Milight, Easybulb, Limitless and futlight clones using Muzzley
☆27Updated 8 years ago
Alternatives and similar repositories for canny
Users that are interested in canny are comparing it to the libraries listed below
Sorting:
- Infrared remote library for ESP8266: send and receive infrared signals with multiple protocols.☆48Updated 9 years ago
- ESP8266 WiFi Smart Thermostat based on Souliss IoT Framework☆108Updated 7 years ago
- MY9291 LED driver library for Arduino ESP8266☆25Updated 7 years ago
- Firmware code and associated utilities for the zmote widget☆21Updated 9 years ago
- Melvanimate☆60Updated 7 years ago
- See Melvanimate: not maintained now.☆22Updated 9 years ago
- WiFi power switch using the ESP8266☆55Updated 9 years ago
- ESP8266 Smart Thremostat☆37Updated 8 years ago
- ESP8266-based smart wall switch☆133Updated 7 years ago
- Alternate firmware for the itead Sonoff based on the Arduino port of ESP8266☆34Updated 8 years ago
- ☆43Updated 9 years ago
- Various Nodes and Helpers for Homie☆20Updated 5 years ago
- ESP8266 displaying mqtt messages on a Nokia 5110 LCD☆70Updated 9 years ago
- ESP8266 port of Opensprikler software.☆37Updated 7 years ago
- ESP8266 / H801 RGB controller using MQTT and WiFi onboarding☆30Updated 3 months ago
- Use the ESP8266 to control your home MiLights using the WiFi gateway bridge connected to the MiLights.☆10Updated 5 years ago
- Full-featured Serial bridge for ESP8266, supports MQTT, WebSockets,Telnet, and also comes with a nice Config Page☆39Updated 2 years ago
- A MQTT to 433/315Mhz RF bridge build on the ESP8266 for home automation☆56Updated 6 years ago
- Full wifi and OTA manager for ESP8266☆109Updated 4 years ago
- MiniESP for ESP01 and modules with few pins, enables GPIO 1/3 disables Serial output.☆29Updated 8 years ago
- Itead Studio SonoffSC custom firmware with MQTT and Domoticz support☆102Updated 5 years ago
- Home Automation Room Controller☆46Updated 9 years ago
- [OUTDATET] Arduino code sample to configure the ESP8266 via http and update Over-the-Air (OTA)☆20Updated 9 years ago
- 433Mhz <-> MQTT gateway for smart home 🏡 automation☆40Updated 7 years ago
- Short examples to use Souliss on ESP8266☆17Updated 8 years ago
- This program enables to: - receive MQTT data from a topic and send RF 433Mhz signal corresponding to the received MQTT data - publish…☆13Updated 7 years ago
- ☆23Updated 7 years ago
- WeMos RFM69 RF Gateway + IC2 Oled + ATSHA204☆24Updated 7 years ago
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- Micro sensor board for MySensor project☆25Updated 2 years ago