google / OctoPrint-HeaterTimeoutLinks
OctoPrint Plugin that automatically shuts down heaters after a specified idle timeout.
☆13Updated 5 years ago
Alternatives and similar repositories for OctoPrint-HeaterTimeout
Users that are interested in OctoPrint-HeaterTimeout are comparing it to the libraries listed below
Sorting:
- OctoPrint plugin that will execute shell commands if a heater exceeds a failsafe threshold.☆27Updated 5 years ago
- OctoPrint plugin that intercepts M150 GCode commands and controls local GPIOs connected to LEDs.☆64Updated 5 years ago
- Plugin for OctoPrint - saves filename, print time and filament usage for each print☆63Updated last year
- Arduino/Marlin firmware flasher for OctoPrint☆40Updated last year
- OctoPrint-Plugin☆10Updated 3 years ago
- Plugin for OctoPrint - displays temperatures on navbar☆45Updated last year
- ☆17Updated 8 months ago
- Some g-code post-processors for 3D printing. This repository hosts the "famous" wood pattern.☆144Updated 3 years ago
- Pegboard Parametric Supports Generator☆161Updated 2 years ago
- ☆114Updated 4 months ago
- Easy to use, well tuned firmware for 3D printers.☆136Updated 3 years ago
- Edit gcode on OctoPrint☆22Updated 2 years ago
- Plugin to analyze gcode for slicer settings comments and add additional metadata of such settings.☆12Updated 2 years ago
- The CR10 Melzi 1.1.2 Motherboard is now fully Open Source☆33Updated 6 years ago
- Plugin for Cura to make debugging settings problems much easier.☆12Updated 3 years ago
- Photonsters Official mods for the Photon User Interface☆32Updated 4 years ago
- ☆43Updated 3 months ago
- A OctoPrint touch interface for TFT touch modules based on GTK+3☆70Updated 5 years ago
- ☆10Updated 2 weeks ago
- An OctoPrint plugin that allows a user to interactively change camera settings.☆56Updated 2 years ago
- ☆20Updated 5 years ago
- Slic3r plugin for slicing within OctoPrint☆93Updated 3 years ago
- Smart control of your power supply via GPIO, GCODE Command, System Command, or variety of sub-plugins.☆213Updated 2 years ago
- Adds RGB LED support to OctoPrint with the ability to choose effects based on the current status of your printer☆34Updated 4 years ago
- ☆140Updated last month
- Use a gcode pre-analysis to provide better print time estimation☆209Updated 10 months ago
- OctoPrint plugin to support closed source printers from FlashForge, PowerSpec, Dremel☆92Updated last year
- The famous, large build area, all-metal 3D printer from Creality3D☆61Updated 6 years ago
- Marlin3dPrinterTool is a open-source software that helps you configure and test your 3D printer.☆264Updated 3 years ago
- ☆62Updated 5 years ago