goat-hill / bitclock
An e-ink desk companion
☆74Updated 3 months ago
Alternatives and similar repositories for bitclock:
Users that are interested in bitclock are comparing it to the libraries listed below
- Introducing OpenRad, a simple radiation monitoring solution powered by the SBM-20 GM tube and TTGO ESP32 microcontroller. this project of…☆54Updated 2 months ago
- This is the wall charger mount version☆85Updated last year
- Gateway between WIFI / LoRa / ESPNOW☆101Updated 3 weeks ago
- ESP32-S3 Thermal Sensor using an 8-bit bus☆79Updated 11 months ago
- ESP32-S3 Framework Expansion Card☆50Updated last year
- Multi-sensor intelligent environmental Monitor☆15Updated 11 months ago
- A palm sized MCH (Metal Ceramic Heater) based reflow hotplate powered by USB-PD☆70Updated 8 months ago
- ESP32-C3 1.54inch E-ink Project☆26Updated last year
- Li-Ion battery charger, based on BQ24060 IC☆42Updated 2 years ago
- Arduino ESP32 based CO2 sensor using a 1.28" round display☆71Updated 2 years ago
- ESP32-C3-DevKit-Lipo RISC-V development board with USB, JTAG, WIFI, BT5, LiPo battery charger☆28Updated 11 months ago
- DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.☆33Updated 3 years ago
- This is the repo of my NanoCell-C3 project, which includes an ESP32 development board I made to simplify the creation of small battery-po…☆54Updated 2 weeks ago
- Optimized library for driving parallel eink displays with the ESP32☆50Updated 2 weeks ago
- ch32v003 USB Driver for 3-digit 7-segment TN LCDs with touch☆159Updated 3 months ago
- Physics Sensor Cube Tux³☆18Updated last year
- Instructions and settings for fabricating PCBs on a fiber laser, namely the xTool F1 Ultra☆80Updated 2 months ago
- Assorted files for my ESP32-S3 development boards☆219Updated 6 months ago
- A minimal breakout board based on the Raspberry Pi RP2040 processor.☆37Updated last year
- An epaper switch project with 2 PCBs, controller+touch, and 220AC to 3DC with Relay (Latch or solid-state)☆29Updated last year
- ☆71Updated 2 years ago
- USB - C Breadboard Powersupply: BrodBoost-C☆138Updated last month
- hardware design for a PCB reflow solder heat plate☆120Updated last year
- A bulk file uploading tool for 3D printer farms.☆41Updated 2 months ago
- A desk clock that uses a Russian IV-18 VFD tube☆25Updated 8 months ago
- Collection of examples to read sensors (I2C and others) and publish real-time information with minimum consumption using fast ESP32S3/ESP…☆37Updated last week
- Official firmware for Unexpected Maker's TinyWATCH S3☆19Updated 2 weeks ago
- ☆121Updated last year
- Gerbers, BOM, and Schematics for Open UpCell [1S]☆23Updated 2 years ago
- ☆93Updated last year