ericwazhung / avr-lvds-lcd
Drive an old laptop display from an 8-bit AVR microcontroller
☆20Updated 9 years ago
Alternatives and similar repositories for avr-lvds-lcd:
Users that are interested in avr-lvds-lcd are comparing it to the libraries listed below
- ☆19Updated 6 years ago
- LCD capture for Rigol DS1074 using UVC on Cypress FX3☆15Updated 3 years ago
- Raspberry PI bare metal☆47Updated 11 years ago
- Andy's Workshop Reflow Oven Controller☆33Updated 7 years ago
- FX2 EZ USB eeprom reader/writer for libusb☆29Updated 2 years ago
- Inlined STM8S SPL (STM8S103) for use with SDCC☆11Updated 6 years ago
- Parse the programmable logic configuration of PSoC devices☆11Updated 7 years ago
- Trying to port the Analog Discovery into libsigrok☆19Updated 10 years ago
- MIPI Display Master Bridge IC Driver and Application Development☆20Updated 11 years ago
- An inexpensive Open Source blackmagic probe compatible SWD debugger designed to be used with ARM GDB.☆35Updated 5 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 4 years ago
- LaunchPad MSP430: 10 independent Delta-Sigma channels instead of PWM☆22Updated 8 years ago
- Experiments getting a Cypress FX3 SuperSpeed USB3 dev kit to behave as a logic analyzer.☆27Updated 7 years ago
- ☆29Updated 8 years ago
- In application debugger for ARM Cortex microcontrollers.☆32Updated 8 years ago
- Solder Paste Dispenser☆18Updated 10 years ago
- USB Full-Speed (12Mbps) protocol analyzer for the DSO Quad☆21Updated 12 years ago
- ESP32/8266 Arduino as (X)SVF JTAG programmer☆43Updated 6 years ago
- FX2 replacement for USB-Blaster from http://fpga4u.epfl.ch/wiki/FX2☆22Updated 10 years ago
- ESP8266 based Raspberry Pi WiFi module☆26Updated 9 years ago
- Fork of GerbMerge from RuggedCircuits.com☆52Updated 9 years ago
- ☆18Updated 4 years ago
- PCB prototype board with different SMT footprints☆12Updated 9 years ago
- Tool to manipulate Cypress EZ-USB FX2LP devices☆17Updated 11 years ago
- USB-PD firmware for the stm32f072 - forked from https://git.clayhobbs.com/pd-buddy/pd-buddy-firmware☆30Updated 5 years ago
- ☆20Updated 8 years ago
- ATMega16U2 firmare - faster than arduino-usbserial☆22Updated 9 years ago
- Android-based multitouch interface for Rigol oscilloscopes☆27Updated 5 years ago
- Example projects for the 1BitSy development boards.☆38Updated last year
- A development board with STM8S105K6 MCU in Arduino UNO form factor☆18Updated 7 years ago