Alternatives and similar repositories for PiMonitor

Users that are interested in PiMonitor are comparing it to the libraries listed below

• Obeisance / SubaruSSMClockPodMod
  Arduino code for OBD communication with GD chassis Subaru WRX
  ☆12Updated 3 years ago
• src0x / LibSSM2
  This C# library provides Subaru specific car diagnostic protocol messages. Reasonable new cars only, old cars use SSM1.
  ☆25Updated 15 years ago
• rpkish / Subduino-SSM
  Subaru Select Monitor to Canbus adapter
  ☆28Updated 7 years ago
• matprophet / subduino
  Arduino project for Subaru SSM to Can-bus conversion
  ☆15Updated 5 years ago
• calvincestari / ecuExplorer
  An open-source application for the Subaru ECU.
  ☆34Updated 7 years ago
• stirobot / arduinoModularTFTgauges
  Modular (configurable via a config file) gauges for 1.8" and other common tft boards
  ☆38Updated 9 years ago
• giotec / ParsePID
  Analyse Extended/Enhanced OBD-II mode 22 capabilities, specifically for Subaru diesel and petrol control units supporting this protocol.
  ☆11Updated 9 years ago
• Merp / SubaruDefs
  Subaru ECU Definitions
  ☆113Updated 2 years ago
• Raperowy / CarTube
  YouTube for Android Auto without ROOT (rootless)
  ☆18Updated 4 years ago
• dschultzca / ScoobyRom
  Subaru electronic control unit ROM analysis tool.
  ☆20Updated 14 years ago
• joukoy / gm-checksum-plugins
  Tunerpro checksum plugins for GM PCM files
  ☆51Updated last year
• kaimitchellm33 / Quest2PyLoader
  A tiny crossplatform sideloader for the Meta Quest 2 & 3 VR Headsets.
  ☆12Updated last year
• xnk / pacific-tpms
  Experimental decoder and encoder for the Pacific PMV-107J TPMS (315MHz) sensors used by Toyota
  ☆32Updated 5 years ago
• andrewkabai / universal_can_filter
  ☆26Updated 5 years ago
• jasminpatry / boostino
  A Teensy 3.6-based logger and gauge for my 2014 Subaru STI.
  ☆16Updated 5 years ago
• festlv / canbus_logger
  CANBus logger using Arduino + MCP2515 with GUI in Python
  ☆24Updated 13 years ago
• BiggRanger / Chrysler-CANBUS-RES-Radio-Interface
  A CANBUS interface for the Chrysler RES Radio
  ☆11Updated 2 years ago
• LSatan / CC1101-Debug-Service-Tool
  With this tool, you can register entries of the CC1101 during operation read and change. You can switch to send or receive. Set the trans…
  ☆48Updated 4 years ago
• educampos28 / OBD2_HACK
  Use ELM327 bluetooth device to evaluate all packages sent through CAN on OBD2 interface.
  ☆58Updated 7 years ago
• LSatan / Simu_Remote_CC1101
  Sending and receiving Simu: Radio motor Hz / Hz02 / EHz / Door control RSA / Radio receiver SA Hz / Garage door operator GM800 / GM1000 M…
  ☆49Updated 4 years ago
• MKme / MasterFrequencyList
  Erics Master Frequency lists for RF tuning
  ☆67Updated last year
• kivijakola / hitager
  ☆79Updated 3 years ago
• CWNE88 / topdogspectrumanalyser
  Python Spectrum Analyser using HackRF or RTL-SDR
  ☆46Updated 8 months ago
• KonradIT / gpauto
  ./gpauto for HERO4/HERO5 (spirtitual successor to autoexec.ash/override.sh/cal.txt) on stock Firmware
  ☆19Updated 5 years ago
• Snirpo / aawireless
  Android Auto USB to Wifi bridge for Raspberry Pi
  ☆21Updated 2 years ago
• ccadic / HackZeGarage
  ESP32-S2 and CC1101S 433Mhz usb stick to record and send car gates/garages data keys and open stuff
  ☆18Updated 4 years ago
• qnx425 / PIC18F25K80-Bootloader
  PIC Bootloader for ELM327SLCAN
  ☆25Updated 6 years ago
• Crowley2012 / SubaruTuning
  ☆14Updated 2 years ago
• lluangrath / VisualME7Logger-Plus
  Continuing development on the already open source VisualME7Logger. This Application pulls data from the Motronic (ME7.1) ECU currently us…
  ☆11Updated 11 years ago
• AprilBrother / ab-hardware
  Hardware files for April Brother
  ☆21Updated 11 months ago