daveydaid / Stewart-Platform-Head-MassagerLinks
Stewart-Gough Platform utilising Dynamixel servo motors. Control loop and simulation handled by PC side, sending control information to Arduino for servo actuation.
☆12Updated 2 years ago
Alternatives and similar repositories for Stewart-Platform-Head-Massager
Users that are interested in Stewart-Platform-Head-Massager are comparing it to the libraries listed below
Sorting:
- ☆31Updated last year
- Open Hardware gaming pads for breadboard.☆11Updated 4 years ago
- NXP MK20DX256 board for the Sparkfun MicroMod system. Should be able to run Teensy 3.2 firmware☆16Updated 5 years ago
- Miniature closed-loop controller for brushless DC motors☆32Updated last year
- A variant of the MP2 electronic speed control with DFNW MOSFETs☆26Updated last year
- Simple design for 16x2 OLED Character Display using the US2066 chip☆13Updated 2 years ago
- Yet Another TruePosition GPSDO☆15Updated 3 years ago
- Control DC motors using SimpleFOC's infrastructure☆32Updated last year
- ☆22Updated 8 years ago
- Serial port emulation over CAN bus☆30Updated 3 years ago
- ☆25Updated 4 years ago
- An Open source controller to convert any servo motor to the best smart servo. Servomotor Hack☆35Updated last year
- LinuxCNC configuration with EtherCAT Servo Drives Leadshine EL8 and some Beckhoff IO Modules☆42Updated last year
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆32Updated 10 months ago
- 8DOF Space Controller Device for FreeCAD☆32Updated 5 years ago
- Dual brushed motor ESC firmware compatible with brushless motor ESCs☆33Updated last year
- Low cost servo drive for small CNC machinery☆54Updated 9 years ago
- USB Sink based around the STUSB4500☆27Updated 5 years ago
- ☆62Updated 2 years ago
- Updated Version of the battery analyzer, now with constant current☆12Updated 4 years ago
- small board to convert linear 3 pin regulator to switching regulator (TO220 compatible, eg 7805)☆11Updated 10 years ago
- Multi-sensor intelligent environmental Monitor☆18Updated last year
- Allows connecting to a LinuxCNC installation and executing commands, similar to linuxcncrsh.☆33Updated 11 months ago
- TMC2209 4 Acis Grbl_ESP32 Controller☆21Updated 4 years ago
- 3D printable - DIY microscope☆14Updated 7 years ago
- C Firmware for QingStation☆16Updated 3 years ago
- ☆47Updated last year
- OpenDrone Project - AIO Brushless FC F405.☆26Updated last year
- Raspberry Pi Pico Home Automation Firmware☆15Updated 3 years ago
- ☆14Updated 3 years ago