cstroie / Arabell300Links
Arabell300 is an Arduino-based 300 baud modem implementing Bell 103 and ITU V.21 standards. Features Hayes-compatible AT commands, AFSK modulation, DTMF dialing, EEPROM configuration profiles, and full-duplex communication. Perfect for vintage BBS systems.
☆26Updated 5 months ago
Alternatives and similar repositories for Arabell300
Users that are interested in Arabell300 are comparing it to the libraries listed below
Sorting:
- Capture traffic on parallel printer port to USB☆90Updated last year
- Arduino library with LCD, Keyboard and SPI Flash support for the SMART Response XE classroom communicator☆101Updated 2 years ago
- Open Programming Firmware for the TL866A Programmer.☆135Updated 3 years ago
- firmware change to improve resolution of a popular "1Hz-50MHz Digital LED DIY Kits Crystal Oscillator Frequency Counter Tester" sold on E…☆25Updated 4 years ago
- V.23 Softmodem for Asterisk with some Bildschirmtext-specific stuff in it.☆69Updated 7 years ago
- Project to talk to IDE interface using Raspberry-Pi GPIO pins in SMI (Secondary Memory Interface bus) mode☆63Updated 8 years ago
- A simple v.23 modem including the data link layer. This is an application for Asterisk☆17Updated 11 months ago
- Capture the output from a computer's parallel printer port.☆42Updated 3 weeks ago
- Schematics of the SMART Response XE terminal☆51Updated 3 years ago
- Documentation of an effort to reverse engineer a Cisco 2501 router, with the end goal to run my own code on it (in particular FreeRTOS)☆31Updated 2 years ago
- Fork of CH55x-USB-Blaster firmware that runs on cheap USB Blaster I got on Amazon☆45Updated last year
- Notes on using TL866II Plus with minipro software on openSUSE☆65Updated 2 years ago
- Flashing Pano Logic thin clients without a programmer☆42Updated 3 years ago
- 1 bit ADC that frames result as serial data. Play the audio with a lowpass on TxD.☆22Updated last year
- This project is a set of AX.25 microservices, to be pluggable for any implementation.☆33Updated 6 months ago
- Reviing the TI92 calculator with a new KICAD PCB and a new 4 inch display☆44Updated 2 years ago
- Tektronix TDS 5xx/6xx/7xx/8xx tools on Linux, ARM, and MacOS☆32Updated 6 years ago
- by NF6X. Forked from: https://gitlab.com/NF6X_Retrocomputing/8051dumper☆26Updated 4 years ago
- Replacement RPN calculator firmware for the diyleyuan calculator.☆39Updated 10 months ago
- A rewrite of Dr. Tony Fisher's software modem for Linux.☆39Updated 5 years ago
- Attiny85-based device to enable and disable write-protection on any SD card☆24Updated 3 years ago
- Classic Phone Modem HAT for the Raspberry Pi☆35Updated last year
- The World's Most Useless Arduino Platform.☆74Updated 4 years ago
- Using an old 8-bit ISA VGA card with Arduino Mega☆23Updated last year
- 1kB TFTP Ethernet bootloader for ATmega328P and ENC28J60☆55Updated 8 years ago
- IBM-PC clone based on an Intel 80386SX processor and an Altera Cyclone IV☆68Updated 9 years ago
- Linux kernel driver for PATA bit-banging over GPIOs☆176Updated 5 years ago
- Drop-in replacements for metal can and half can style crystal oscillators☆46Updated 5 years ago
- A v23 softmodem☆16Updated 8 years ago
- arduino library to interface with 30-pin simm ram☆80Updated 10 years ago