csouers / chrysler-ccd
Code to read and write to the Chrysler CCD bus.
☆11Updated 8 years ago
Alternatives and similar repositories for chrysler-ccd:
Users that are interested in chrysler-ccd are comparing it to the libraries listed below
- Hardware and software for interfacing Chrysler's legacy CCD/PCI/SCI-bus.☆54Updated this week
- DRB-III database reader.☆40Updated 6 years ago
- CCD (Chrysler's Collision Detection) Data Bus protocol decoder for Sigrok☆11Updated 2 years ago
- Chrysler Dodge Jeep Plymouth Scanner☆25Updated 4 years ago
- Arduino library for interfacing Chrysler's legacy CCD-bus using the CCDBusTransceiver development board.☆19Updated 3 years ago
- ☆19Updated 7 years ago
- J1850VPW Transceiver Library for Arduino☆28Updated last year
- Projects around CAN BUS in Chrysler Jeep - VES enabler, other small features☆28Updated 2 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆39Updated last year
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆42Updated 2 months ago
- ECU designed for Speeduino firmware☆30Updated 5 years ago
- ☆38Updated 4 months ago
- Arduino Due solution for adding vin-coded modules to BMW cars☆55Updated 6 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- File converter from DBC to RealDash XML☆14Updated 6 months ago
- ECU designed for Speeduino firmware☆10Updated 6 years ago
- Development board for interfacing Chrysler's legacy CCD-bus (no CDP68HC68S1 chip needed).☆10Updated 3 years ago
- Arduino STM32. Hardware files to support STM32 boards, on Arduino IDE 1.6.5 including LeafLabs Maple and other generic STM32F103 boards. …☆13Updated 6 years ago
- Firmware for canbus boxes☆73Updated last year
- STM32 based Arduino Mega replacement for speeduino☆82Updated last week
- ELM327 based vehicle's CAN bus sniffer☆55Updated 6 years ago
- ☆67Updated this week
- ☆16Updated 3 weeks ago
- Reads VW/Audi specific measuring blocks over an OBD-II port using an ELM327 adapter☆109Updated 4 years ago
- Fulcrum is the ultimate J2534 DLL Shim written in C++ which is able to pipe data out from the native calls to any other location for supe…☆30Updated last year
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆72Updated 11 years ago
- Arduino / ESP / RPi Pico library integrating the proprietary VAG Key-Word 1281 protocol (KWP1281/KW1281)☆50Updated 2 months ago
- ☆21Updated 2 years ago
- Jetta TDI aux display☆18Updated 5 years ago
- arduino library for remote controling V.A.G. radios☆10Updated 3 years ago