majekw / sigrok-ccd-pdLinks
CCD (Chrysler's Collision Detection) Data Bus protocol decoder for Sigrok
☆12Updated 2 years ago
Alternatives and similar repositories for sigrok-ccd-pd
Users that are interested in sigrok-ccd-pd are comparing it to the libraries listed below
Sorting:
- Hardware and software for interfacing Chrysler's legacy CCD/PCI/SCI-bus.☆62Updated this week
- Development board for interfacing Chrysler's legacy CCD-bus (no CDP68HC68S1 chip needed).☆11Updated 3 years ago
- Code to read and write to the Chrysler CCD bus.☆11Updated 9 years ago
- ☆40Updated 4 months ago
- ☆58Updated last week
- ☆22Updated 7 years ago
- Chrysler Dodge Jeep Plymouth Scanner☆26Updated 5 years ago
- Hellen-One Hardware Platform for rusEFI Engine Management System☆23Updated last week
- A DIY soldering controller for JBC T245 handle & C245 tips☆40Updated last year
- Firmware for the cheapest can sniffer☆37Updated last year
- ☆10Updated 4 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆78Updated 11 years ago
- Development board for interfacing Chrysler's legacy CCD/PCI-bus☆11Updated last year
- A DIY soldering controller for JBC T245 handle and PA120 micro tweeezers☆13Updated last year
- CAN (Dual) bus Arduino library for stm32F042, stm32F103, stm32F105, stm32F107, stm32L4, stm32F4☆25Updated 2 years ago
- Arduino library for interfacing Chrysler's legacy CCD-bus using the CCDBusTransceiver development board.☆19Updated 3 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆80Updated last week
- CAN Bus logger with SD card implemented using ChibiOS☆70Updated 6 years ago
- DRB-III database reader.☆44Updated 7 years ago
- VAGCANLOGGER - KW1281 & VW TP 2.0☆33Updated 11 years ago
- microRusEfi board for rusEfi ECU☆75Updated 7 months ago
- Reading the K-line of the bus according to ISO 14230-4 KWP 10.4 Kbaud☆24Updated 5 years ago
- ☆26Updated this week
- Wideband Lambda Controller with Bosch CJ125☆38Updated last year
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆27Updated last year
- ☆20Updated 7 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆17Updated last year
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆48Updated 2 months ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆31Updated last year