blezalex / WheelBoardMainLinks
Balancing controler for monowheeled skateboard.
☆29Updated 3 months ago
Alternatives and similar repositories for WheelBoardMain
Users that are interested in WheelBoardMain are comparing it to the libraries listed below
Sorting:
- Arduino based accessory board for the balance app in BV's BLDC firmware.☆20Updated 4 years ago
- Firmware for DAVEga, a device for electronic skateboards that displays data read from VESC based speed controllers.☆58Updated 4 years ago
- ☆71Updated 8 years ago
- BLDC Motor Controller based on the VESC 4.12 hardware☆74Updated 5 years ago
- The source code for VESC Tool. See vesc-project.com☆88Updated 3 years ago
- nRF52 iBeacon with rotating beacon identity☆17Updated 7 years ago
- rESCue - add more safety and control to your VESC based vehicle☆123Updated 4 months ago
- A small Converter to convert Futaba SBus to PPM or Spektrum-Serial☆42Updated 9 years ago
- An Atmega328P based 2.4GHz receiver with integrated TB6612FNG motor driver. PWM and SBUS outputs.☆148Updated last year
- Library for reading and writing files for the Anycubic Photon 3D-Printer (.photon and .cbddlp)☆25Updated 4 years ago
- Arduino library to interface with the VESC bldc over UART.☆146Updated 3 years ago
- bradwii on Mini54ZAN for JD385/V202☆27Updated 10 years ago
- An Arduino library for interfacing with the VESC over UART☆217Updated last year
- Official VESC Packages☆44Updated last week
- Hoverboard Hack Firmware Generation 2 for the Hoverboard with the two Mainboards instead of the Sensorboards (See Readme.md).☆169Updated 4 years ago
- opensource implementation of the frsky protocol for multiple targets (D4R-ii, VD5M)☆162Updated 5 years ago
- Cheerson CX10 (red) arduino PPM TX☆19Updated 7 years ago
- USB joystick to PPM using Raspberry Pi☆80Updated 8 years ago
- Simple, open-source ESC that uses the SimonK firmware.☆196Updated 9 years ago
- Thrust stand data logger utilising the dshot600 protocol and ESC telemetry.☆92Updated 3 years ago
- In this project, I want to read out telemetry data of the "VESC" speed controller by Benjamin Vedder via UART and display it on an OLED d…☆37Updated 8 years ago
- ☆30Updated 8 years ago
- Active precharce circuit with optional switch input☆50Updated 9 years ago
- ☆149Updated 6 years ago
- BLE-UART bridge for the VESC with packet handling and VESC Tool compatibility☆63Updated 10 months ago
- Closed loop control 3D printer from old inkjet printers☆40Updated 7 years ago
- ☆74Updated last year
- GoodEnoughCNC Hybrid (Plasma, Mill) - very low cost and simple, suitable for everyone☆78Updated 6 years ago
- Low-Cost Motor Controller based on the VESC 6☆360Updated last year
- Deluxe OSD 5.8GHz (rx5808 module) control based on minimOSD Ardunino board☆133Updated 9 years ago