bleroy / 3d-junkyardLinks
Random 3D models
☆57Updated last month
Alternatives and similar repositories for 3d-junkyard
Users that are interested in 3d-junkyard are comparing it to the libraries listed below
Sorting:
- 4MB RAM expansion for Atari 520ST(M)☆44Updated 3 years ago
- 14MHz 68000 accelerator with 1MB fast ram for amiga 500☆78Updated 4 years ago
- This is an Enhanced version of the 1581 Drive PCB.☆50Updated last year
- A NodeMCU (ESP8266) based WiFi modem for the C64's user port☆85Updated 2 years ago
- SRAM substitute for C64C shortboards☆61Updated 7 years ago
- ☆33Updated 10 months ago
- A ColecoVision clone☆18Updated 6 months ago
- ATARI XE Replacement Keyboard☆13Updated 2 years ago
- Solution for multisync switch for Atari ST/STE.☆32Updated 4 years ago
- Bootloader & Firmware Updater☆20Updated 10 months ago
- This is a small adapter, in the form of a daughter board, which fits into the socket of the "Sally" CPU of the Atari 800XL microcomputer.…☆32Updated 4 years ago
- I wanted a Pi1541 module that did not feel like I was handling bare electronics, so I made one that hides most of the scary bits (no 3d-p…☆55Updated 4 years ago
- Open source clone of the Commodore 128 computer☆65Updated 4 months ago
- An RGB adapter for TMS9928A and TMS9929A☆59Updated 5 years ago
- This projects provides alternate firmware for A2VGA cards to add USB support to the Apple II. It currently supports a USB mouse and full…☆20Updated last year
- Hardware design of Magic Desk compatible C64 cartridge up to 512k☆74Updated 7 months ago
- PS/2 to C64 Mouse Adapter☆64Updated 10 years ago
- A small daughterboard adapter that replaces a 6502 processor (used in vintage 8-bit computers such as the VIC-20, Apple II and BBC Micro)…☆41Updated 4 years ago
- An adapter for Atari (ST/Falcon/TT - only tested on Falcon) / Amiga +Mouse : USB to DB9 (Quadrature encoded).☆21Updated 6 months ago
- Amiga 500 Custom Mechanical Keyboard☆40Updated 5 months ago
- A remix of the NeoRAM catridge for the Commodore 64.☆41Updated 5 years ago
- A Vic-20 clone created with [almost] all readily available parts☆69Updated 2 years ago
- Various PCB and case designs of the SmartPortSD hard disk emulator for Apple II computers.☆50Updated 6 months ago
- ☆71Updated 11 months ago
- A conversion to Kicad EDA of the schematics of a computer released around 1989 known as the "Atari STE".☆31Updated 2 weeks ago
- Interface to allow Super Nintendo (SNES) control pads to be plugged into a C64's joystick ports.☆39Updated 3 years ago
- Connect USB keyboard and mouse to Atari ST using a Raspberry PI emulating the HD6301 keyboard controller☆36Updated 4 years ago
- MOS CPU Replacer – replace rare/expensive/unreliable MOS CPUs☆87Updated 11 months ago
- ☆59Updated 3 years ago
- A cartridge for the TI 99/4A that runs ROM and GROM images from an SD card☆82Updated 2 years ago