bdring / TWANG
Arduino-based 1D dungeon crawler
☆17Updated 5 years ago
Alternatives and similar repositories for TWANG:
Users that are interested in TWANG are comparing it to the libraries listed below
- ☆19Updated 3 years ago
- Simple design for 16x2 OLED Character Display using the US2066 chip☆11Updated last year
- Arduino based moonflower disco light☆14Updated 4 years ago
- Repository to share my custom 3D printing designs☆12Updated 5 years ago
- A simple continuity tester, based on an ATtiny85 and a piezo buzzer.☆18Updated 7 years ago
- Originally intended to be a controller for a RetroPie. A soft power controller that allows for Raspberry Pi proper shutdown. Intention is…☆22Updated 7 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 4 years ago
- a DIY flat christmas decoration with a ATtiny25, 20 led´s and a coin cell battery☆25Updated 4 years ago
- ☆24Updated 7 years ago
- Firmware for the Silver open-source, long-range camera remote control☆15Updated 4 years ago
- ☆14Updated 4 years ago
- Reflow Oven from the KMart mini oven☆10Updated last month
- esp8266 controller based on SVG with embedded links☆10Updated 3 years ago
- ☆13Updated 7 years ago
- ☆35Updated 5 years ago
- A Serial-To-Parallel data transmission device, built with the ATMEGA328.☆12Updated 6 years ago
- Calibration of the internal RC oscillator of atmega328p chip, and UART bootloader(ATmegaBOOT) without crystal.☆20Updated last year
- Tiniest USB-C LiPo charger☆34Updated 2 years ago
- ESP32-S2 1.54" x 1.54" TFT Display Board☆11Updated 3 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 4 months ago
- ESP32_CAM meets Etch-A-Sketch => Etch-a-Selfie☆12Updated 5 years ago
- Electronic Paper Display libraries and examples☆44Updated 7 years ago
- ☆12Updated 4 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- Playing around with the Padauk MCUs☆33Updated 4 years ago
- A clock with 241 RGB LEDs☆19Updated 2 years ago
- A repository with all my custom symbols for KiCad☆21Updated 2 months ago
- My design files. Abandon all hope ye who enter here.☆30Updated 2 years ago
- It is compatible with standard stepper motor diver, cnc or GRBL shield, direct replacement of X-Y stepper motors.☆27Updated 5 years ago
- Eagle scripts for LED matrix display generation☆14Updated last year