apollo-ng / PiGILinks
The PiGI is built as a ready-to-go drop-in module for the Raspberry Pi to transform it into a versatile geiger counter to measure/monitor radioactivity. It will generate the required high voltage the counting tubes need to operate and it will safely invert the counting impulses to a falling edge, detectable by a GPIO Pin on the PI. But it's also…
☆58Updated 6 years ago
Alternatives and similar repositories for PiGI
Users that are interested in PiGI are comparing it to the libraries listed below
Sorting:
- Firmware for my ESP32-based hand-rolled LWIR camera device☆50Updated 7 years ago
- A hackable open source sensor IoT board with network interface. A DIY Geiger counter KIT to contribute readings to the uRADMonitor networ…☆81Updated 2 years ago
- AS3935 Franklin Lightning Sensor™ IC by AMS Arduino library☆48Updated 11 years ago
- datasheet and Arduino demo code for LoRa Radio Node v1.0☆48Updated 7 years ago
- CDM324 Amplification Backpack, With Case and Simulations☆63Updated 8 years ago
- Portable radiation detector based on an ionization chamber☆62Updated 2 years ago
- RDA1846 VHF/UHF Transceiver Chip I2C library for Arduino☆64Updated 7 years ago
- snippets that were too small for their own library☆37Updated 7 years ago
- Scans LoRa channels displaying any monitored packets on the TFT display☆93Updated 8 years ago
- 1-channel gateway based on ESP8266 mcu☆36Updated 8 years ago
- SAMD21 Development Board with LoRa and GPS☆36Updated 7 years ago
- Noise resilient DCF77 decoder library for Arduino☆101Updated 9 months ago
- Raspberry PI Lora Gateway/Node for RFM92/95/96/98/69HCW Modules☆62Updated 9 years ago
- Test using tp-links to do raw wifi.☆44Updated 8 years ago
- Schematics and code for the Re:load Pro☆102Updated 8 years ago
- Set the voltage of a Quick Charge 2.0 source via the Arduino.☆68Updated 8 years ago
- LoRa HAB Repeater☆45Updated 6 years ago
- nordic semiconductor wireless chipsets related code☆43Updated 11 years ago
- Breakout board for LoRa all-in-one module CMWX1ZZABZ☆13Updated 5 years ago
- Pi Zero RAK831 Adapter board☆104Updated 7 years ago
- Simple LoRa Node based on Arduino Pro mini with RFM95W module and PCB antenna.☆65Updated 6 years ago
- Open-Source firmware for the ZPB30A1 electronic load (WIP)☆52Updated 7 years ago
- Reflow Oven Controller. See below for more information.☆79Updated 6 years ago
- GUI for pcb2gcode☆137Updated 4 months ago
- New and improved version of the GC-01 geiger counter with wifi and logging functionalities☆87Updated 2 years ago
- LoraWAN gateway with RAK831/iC880A and Raspberry Pi Zero W for TheThingsNetwork☆111Updated 4 years ago
- Measures the elapsed time during each cycle of an input frequency.☆74Updated 3 years ago
- Small Lora(WAN) board using an Atmega1284P chip and RFM95 module☆20Updated 2 years ago
- Arduino library for DRA818 VHF/UHF Band Voice Transceiver☆49Updated 2 years ago
- 1-channel gateway based on ESP8266 mcu☆69Updated 8 years ago