alexyu132 / zcar2
3D-printed 1:28 scale 4WD drift car
☆53Updated 4 years ago
Alternatives and similar repositories for zcar2:
Users that are interested in zcar2 are comparing it to the libraries listed below
- 1/28 scale rc car chassis☆78Updated 4 years ago
- Marlin Laser working version with RAMPS Generic config☆20Updated 4 years ago
- ESP32 DIY Digital Readout☆93Updated 5 years ago
- 3D Printed 3 Axis Camera Slider, remote controlled via Bluetooth☆29Updated 3 years ago
- DIY Printed small PCB CNC for fast Prototyping☆46Updated 3 years ago
- FYSETC Board - The E4 board is a minimal 3D printer control board based on the ESP32 microcontroller from ESPRESSIF, with built-in Wi-Fi …☆67Updated 3 weeks ago
- MKS TFT32/28 alternative firmware☆68Updated 7 years ago
- The RAMPS 1.6 is the second RAMPS iteration released by BIGTREETECH. It replaces the original green power connector with a pair of screw …☆88Updated 5 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆76Updated 11 months ago
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 3 months ago
- Adapter board to use a Raspberry Pi as a Linux CNC controller☆58Updated 2 years ago
- Z-height sensor board add-on for RepRapPro Ormerod 3D printer☆103Updated 8 years ago
- DIY WiFi Filament dryer☆160Updated last year
- A Grbl_ESP32CNC Controller for MPCNC☆88Updated 3 years ago
- ☆58Updated 2 years ago
- 3D printer control board based on ESP32,support 8 Driver motors.☆76Updated 2 years ago
- CAN bus extruder, more resistant to noise,reduce a lot of wires for your 3D printer☆113Updated last year
- A Pendant for FluidNC CNC Firmware☆50Updated last week
- MKS DLC support grbl firmware, can use Laser mode and CNC mode,support connect MKS TFT24/32/35 and TFT_CNC firmware support lasering and …☆98Updated 3 years ago
- ☆36Updated 3 years ago
- Arduino adapter for RC remote control PPM signal to USB HID Joystick☆27Updated 2 years ago
- 3D printer / slicing GUI built on top of the Uranium framework☆35Updated 4 years ago
- A cheap DIY selfmade 3D-Mouse to use in Solidworks☆32Updated 8 years ago
- Heavy Duty 3D Printed CNC Machine☆86Updated last year
- MATLAB/Arduino code for DIY 3D Scanner Project featured in Super Make Something Episode 8☆38Updated last year
- ☆55Updated 3 years ago
- Lixie II - Open Source Hardware files!☆41Updated 4 years ago
- ☆57Updated 5 years ago
- faceless clock☆55Updated 6 years ago
- Alternative to PanelDue. Embedded UI for Duet & RepRap based 3D printers. Running on the ESP32. Optimized for 3.5" displays. WiFi or UART…☆91Updated 2 years ago