ZacharyWalsh57 / GyroCubeLinks
A PID Based Self Balancing Cube!
☆11Updated 7 years ago
Alternatives and similar repositories for GyroCube
Users that are interested in GyroCube are comparing it to the libraries listed below
Sorting:
- ☆20Updated 8 months ago
- A combined frame and 4in1 brushless ESC running BLHeli_s with 16mm hole spacing☆10Updated 7 years ago
- A BLDC controller developed (HardWare + FirmWare) using SimpleFOC that is aimed to be used as a robotic actuator.☆15Updated 2 years ago
- Low speed IAS Airspeed sensor for UAVs☆16Updated 4 months ago
- OpenGrab Electropermanent Magnet☆34Updated 2 years ago
- Transition mixes for a radio controlled VTOL bicopter☆36Updated 6 years ago
- Open Source Brushless DC Servo☆13Updated 6 years ago
- tinyPEPPER2 4in1 ESC☆27Updated 7 years ago
- Optical flow X-Y velocity sensor plus 35 x 35 pixel 15 Hz video camera☆13Updated last year
- Recovery beacon for lost UAVs☆14Updated 4 years ago
- ☆74Updated last year
- Control DC motors using SimpleFOC's infrastructure☆27Updated 11 months ago
- Differential Steering with a single dual axis Joystick in Arduino☆16Updated 3 years ago
- ☆38Updated last year
- This project aims to provide a compact, easy to use, relatively high resolution and arguably cheap encoder. It uses the AS5040 magnetic r…☆12Updated 9 years ago
- This Arduino sketch expands the SBUS using an Arduino such as a small Ardiono Nano or ProMicro making the full 16 channels available on y…☆27Updated 4 years ago
- ☆11Updated 3 years ago
- Miniature closed-loop controller for brushless DC motors☆29Updated 10 months ago
- PWM to SBUS and PPM converter (pwm2ppm, pwm2sbus) for Arduino AVR atmega328p☆29Updated 8 years ago
- An Arduino-based flight controller for fixed-wing multipropeller aircraft capable of carrying out autonomous flight missions☆11Updated 4 years ago
- ☆22Updated 8 years ago
- Firmware for 3 Phase BLDC controller☆41Updated 5 years ago
- ☆40Updated 6 months ago
- a Micropython driver for the SBUS protocol☆28Updated 8 years ago
- I came up with a design for a 3D printed Dynamic Spin Balancer using an ESP32, an MPU6050 and a hall sensor to help balance out my wheels…☆12Updated 3 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 7 months ago
- Microcontroller files to access the Batmon battery monitor☆23Updated 2 weeks ago
- DIY Multiprotocol TX Module☆14Updated 4 months ago
- a flight controller for a ppm receiver and mpu6050 stabilizer☆10Updated 5 years ago
- CAD files for a crazyflie drone test gimbal☆30Updated last year