StoneSet / furrtek_eslLinks
The ESL project of furrtek, with board, apk and hex files
☆14Updated 6 years ago
Alternatives and similar repositories for furrtek_esl
Users that are interested in furrtek_esl are comparing it to the libraries listed below
Sorting:
- Wireless tool to communicate with IR based ESLs from a smartphone ;-)☆65Updated last year
- You know what this is for ;-)☆312Updated 6 months ago
- ☆77Updated 2 years ago
- ☆14Updated 5 years ago
- ☆79Updated last year
- Reverse-engineering of rechargeable disposable vapes that include a small color TFT LCD (Raz/Kraze/etc.)☆174Updated 4 months ago
- This project aims to develop a CAN (Controller Area Network) adapter for the Flipper Zero, allowing users to connect devices with a CAN i…☆41Updated 8 months ago
- Sending and receiving Simu: Radio motor Hz / Hz02 / EHz / Door control RSA / Radio receiver SA Hz / Garage door operator GM800 / GM1000 M…☆42Updated 4 years ago
- Flipper addons by Electronic Cats☆104Updated last month
- send pocsag messages inside RF22 on si4432-based ISM modules☆40Updated 11 years ago
- Analogue TV transmitter for the HackRF☆70Updated 2 weeks ago
- A clone of the ELECHOUSE_CC1101 http://www.elechouse.com library updated for Arduino 1.0 plus.☆93Updated 6 years ago
- Moddings for Proxmark3☆33Updated last year
- Send sketches wirelessly from the Arduino IDE to your SMART Response XE☆37Updated 7 years ago
- ☆64Updated last year
- A NOT FINISHED Flipper Zero Clone created from the open src schematic and the open src firmware☆83Updated last year
- A remote control clone of an RC-switch using Arduino Nano and a TI CC1101 module☆33Updated 5 years ago
- Blog about my journey investigation uhf-rfid with arduino and cc1101☆50Updated 3 years ago
- With this tool, you can register entries of the CC1101 during operation read and change. You can switch to send or receive. Set the trans…☆44Updated 4 years ago
- Terminal app for RYLR896 for Flipper Zero☆36Updated last year
- An evolving collection of wireless exploration tools for the ESP32. Be the unseen force. Initially 802.11 the goal is to include Bluetoot…☆77Updated last year
- ESP32-S2 and CC1101S 433Mhz usb stick to record and send car gates/garages data keys and open stuff☆16Updated 3 years ago
- Flipper Zero Firmware☆17Updated 3 years ago
- Arduino library for TI CC1101. Supports the latest Arduino IDE and Platformio. Tested with AVR atmega328, stm32f103, nodeMCU and probably…☆51Updated 8 months ago
- Arduino RF rolling code keeloq receiver☆26Updated last year
- Expansion board for Raspberry PI allowing to use coaxial SMA output instead of direct wire connection to GPIO to connect radio equipment …☆34Updated 9 months ago
- [WIP] Leverage Flipper Zero SPI ports to interact with MCPXXXX and provide CANbus Sniss Knife inside your pocket. Kind of Linux's Canutil…☆42Updated last year
- Attiny85-based device to enable and disable write-protection on any SD card☆22Updated 3 years ago
- Simple RFID Emulator / Cloner☆26Updated 8 months ago
- This repo will mainly containt generated keys of Skylanders toys to be used with Flipper Zero.☆71Updated 2 years ago