Juan-Gg / Linear-lab-bench-power-supplyLinks
This is a dual channel linear lab power supply, each one capable of 30 V at 500 mA.
☆13Updated 6 years ago
Alternatives and similar repositories for Linear-lab-bench-power-supply
Users that are interested in Linear-lab-bench-power-supply are comparing it to the libraries listed below
Sorting:
- Porting the great SMC3 servo motor controller by Elm Chan to an ATmega328☆17Updated 6 years ago
- Open Source Lab Power Supply☆28Updated 3 years ago
- LCR meter project. An Inductance, Capacitance and Resistance meter, Arduino NANO(v3) based.☆94Updated last year
- Simple Logic Probe☆42Updated 2 years ago
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆26Updated last year
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- Electronic Dummy Load☆47Updated 2 years ago
- Open Source LC-Meter. All documentation included.☆81Updated 3 years ago
- DIY Electronic load for DCDC converter characterization☆50Updated 4 years ago
- Arduino-based battery internal resistance meter☆45Updated 8 years ago
- Open-source USB frequency counter☆24Updated last year
- Open Source 10Mhz Isolated Distribution Amplifier. PIC18F25K50 TruePosition GPSDO Controller Firmware with USB and OLED Display.☆17Updated 3 years ago
- Simple RPM-Meter☆57Updated 2 years ago
- ☆16Updated 10 years ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆26Updated 2 years ago
- ☆9Updated 4 years ago
- Digital Readout sketch files for the Arduino IDE☆10Updated 5 years ago
- A new design for a digital bench power supply built using the Atmega8.☆8Updated 10 years ago
- ESTechnical Reflow Oven Controller source code and instructions☆47Updated 10 years ago
- An AVR Programmer based on USBasp which uses a ZIF-Socket for Programming.☆12Updated 3 years ago
- Semi-automatic passive printable/castable feeder for LitePlacer☆59Updated 5 years ago
- The soldering controller for hakko 907 with lcd screen☆29Updated 6 years ago
- Power Supply Analyzer with USB Interface☆52Updated 2 years ago
- Capacitance meter, Arduino-based, three tests , range 18pf to 4F , Push Button input , OLED and serial monitor output.☆18Updated last year
- tape puller/remover for 0816 automatic feeder☆21Updated 6 years ago
- Hardware of Jasper's Electronic Load R3☆25Updated 6 years ago
- Simple USB-C Power Delivery Tester☆38Updated 2 years ago
- Soldering and rework station with TFT ili9341 display absed on stm32☆22Updated 8 months ago
- AVR Fuse Rescue Shield based on high voltage programmer by Jeff Keyzer aka MightyOhm.☆16Updated 2 years ago
- DIY portable Wi-Fi enabled signal generator☆42Updated 4 years ago